Forum Technical Discussions bosch specification Posted by: wayne seemungal    (PID_3104), E-mail: Address, on May 30, 2008 at 23:00 : Does anyone have any experience with a Bosch UT specification on round/hex steel bars. I believe it is a FBH (0.6mm??). Is this to be detected in a static or dynamic mode? Follow Ups: Re: bosch specification S.V.Swamy 08:14 Jun-04-2008 (0) Post a Followup: Name: E-Mail: Subject: Comments: ----------- Start Original Message ----------- : Does anyone have any experience with a Bosch UT specification on round/hex steel bars. I believe it is a FBH (0.6mm??). Is this to be detected in a static or dynamic mode? ------------ End Original Message ------------ Optional Link URL: Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP Page Title: is important! Optional Image URL: http://www....gif Attention! Please click the button only once. This may take a moment to process Forum Technical Discussions Help