Forum Technical Discussions Re: bosch specification Posted by: S.V.Swamy (PID_839), E-mail: Address, on June 04, 2008 at 08:14 : In Reply to: bosch specification posted by : wayne seemungal    , E-mail: Address, on May 30, 2008 at 23:00 : ----------- Start Original Message ----------- : Does anyone have any experience with a Bosch UT specification on round/hex steel bars. I believe it is a FBH (0.6mm??). Is this to be detected in a static or dynamic mode? ------------ End Original Message ------------ Dear Wayne, While I have no direct experience with the specification that you have referred, I would expect that whatever method you are using to do the ultrasonic testing (by hand or by using some equipment to rotate the bar and to move the probe along the length), you would need to demonstrate that the reference standard is being picked up successully and consistently. So, you should have a reference standard which goes through the same equipment and test method as the actual rods. Follow Ups: Post a Followup: Name: E-Mail: Subject: Comments: ----------- Start Original Message ----------- : : Does anyone have any experience with a Bosch UT specification on round/hex steel bars. I believe it is a FBH (0.6mm??). Is this to be detected in a static or dynamic mode? : Dear Wayne, : While I have no direct experience with the specification that you have referred, I would expect that whatever method you are using to do the ultrasonic testing (by hand or by using some equipment to rotate the bar and to move the probe along the length), you would need to demonstrate that the reference standard is being picked up successully and consistently. So, you should have a reference standard which goes through the same equipment and test method as the actual rods. ------------ End Original Message ------------ Optional Link URL: Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP Page Title: is important! Optional Image URL: http://www....gif Attention! Please click the button only once. This may take a moment to process Forum Technical Discussions Help