Forum Technical Discussions Re: ASME SA 435 vs SA 578 Posted by: Manfred Richter (PID_3413), E-mail: Address, on June 04, 2008 at 18:48 : In Reply to: ASME SA 435 vs SA 578 posted by : mustafa GONULAL , E-mail: Address, on June 04, 2008 at 16:48 : Mr. Gonulal, the acceptance criteria are not the same. In A-578 level B there is an additional requirement for interaction of smaller discontinuities. (See ASTM A-578 item 8.2) regards, ----------- Start Original Message ----------- : Dear Specialists, : ASME SA 435 and SA 578 code requires straigth beam examination of carbon steel plates greater than 12mm. SA 435 and SA 578 Level B hvae the same acceptance criteria. : If a plate has been inspected in acc. with SA 578 Level B, and the code requires SA 435 inspection. Is there any Code interpretetion or experience with ASME Code work? ------------ End Original Message ------------ Follow Ups: Re: ASME SA 435 vs SA 578 mustafa GONULAL 08:28 Jun-05-2008 (0) Post a Followup: Name: E-Mail: Subject: Comments: ----------- Start Original Message ----------- : Mr. Gonulal, : the acceptance criteria are not the same. In A-578 level B there is an additional requirement for interaction of smaller discontinuities. (See ASTM A-578 item 8.2) : regards, : : Dear Specialists, : : ASME SA 435 and SA 578 code requires straigth beam examination of carbon steel plates greater than 12mm. SA 435 and SA 578 Level B hvae the same acceptance criteria. : : If a plate has been inspected in acc. with SA 578 Level B, and the code requires SA 435 inspection. Is there any Code interpretetion or experience with ASME Code work? ------------ End Original Message ------------ Optional Link URL: Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP Page Title: is important! Optional Image URL: http://www....gif Attention! Please click the button only once. This may take a moment to process Forum Technical Discussions Help