Forum Technical Discussions Re: x ray Posted by: Afshun Agha Amiri , E-mail: Address, on August 09, 2008 at 11:38 : In Reply to: Re: x ray posted by : Nigel , E-mail: Address, on August 08, 2008 at 17:03 : ----------- Start Original Message ----------- Dear Friend, In industrial RT For proper recommendations about energy selection and relevant thickness limitation on steel materials,you can refer to some code/standards(such as BS/EN1435 or old version of ASMEsec.5-before 1998),ASNT RT handbook,ASM handbook(vol.17)and others reference books. 2%sensitivity means : as a RT quality criteria and be checked by IQI,is 2% of test material thickness which is minimum detectable defect size through thickness. you may obtain 2% sensitivity by x-ray or gamma-ray. You can refer to ASM handbook(vol.17). Follow Ups: Re: x ray tj 13:20 Nov-14-2008 (0) Re: x ray gowrishankar 06:31 Aug-12-2008 (0) Post a Followup: Name: E-Mail: Subject: Comments: ----------- Start Original Message ----------- : Dear Friend, : In industrial RT For proper recommendations about energy selection and relevant thickness limitation on steel materials,you can refer to some code/standards(such as BS/EN1435 or old version of ASMEsec.5-before 1998),ASNT RT handbook,ASM handbook(vol.17)and others reference books. : 2%sensitivity means : as a RT quality criteria and be checked by IQI,is 2% of test material thickness which is minimum detectable defect size through thickness. : you may obtain 2% sensitivity by x-ray or gamma-ray. : You can refer to ASM handbook(vol.17). ------------ End Original Message ------------ Optional Link URL: Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP Page Title: is important! Optional Image URL: http://www....gif Attention! Please click the button only once. This may take a moment to process Forum Technical Discussions Help