Forum Technical Discussions      Reference Sensitivity for fusion plus weld test of T joints Posted by: N.Kuppusamy (PID_1818), E-mail: Address, on October 06, 2008 at 15:06 : In Reply to: Reference Sensitivity for fusion plus weld test of T joints posted by : N.Kuppusamy , E-mail: Address, on October 06, 2008 at 06:13 : What is the reference sensitivity required for 0° probe, when testing the fusion zone (and weld) of Full Penetration Joints from main member side? Whether Lamination test sensitivity (2nd back wall echo at 80% etc) is acceptable or we need to make a DAC using SDH? Consider the following codes: Case 1: According to ABS Guide Case 2: According to AWS D1.1 Case 3: According to API RP 2X Follow Ups: Post a Followup: Name: E-Mail: Subject: Comments: ----------- Start Original Message ----------- : What is the reference sensitivity required for 0° probe, when testing the fusion zone (and weld) of Full Penetration Joints from main member side? : Whether Lamination test sensitivity (2nd back wall echo at 80% etc) is acceptable or we need to make a DAC using SDH? Consider the following codes: : Case 1: According to ABS Guide : Case 2: According to AWS D1.1 : Case 3: According to API RP 2X ------------ End Original Message ------------ Optional Link URL: Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP Page Title: is important! Optional Image URL: http://www....gif Attention! Please click the button only once. This may take a moment to process Forum Technical Discussions Help