Forum Technical Discussions      Re: UT for below 8mm thk Posted by: NEELA , E-mail: Address, on October 26, 2008 at 07:23 : In Reply to: UT for below 8mm thk posted by : gowri santhosh , E-mail: Address, on October 25, 2008 at 14:03 : ----------- Start Original Message ----------- : hi, this is santhosh : please tell me about UT for below 8mm thickness with reference code. thanks for reply. ------------ End Original Message ------------ As per AWS D 1.1 you cannot peform UT below 8mm thickness It require client acceptance and special calibration block required Follow Ups: Re: UT for below 8mm thk Tom Nelligan 13:55 Oct-27-2008 (3) Re: UT for below 8mm thk David Harvey 16:12 Oct-27-2008 (2) Re: UT for below 8mm thk athar hussai 07:57 Nov-04-2008 (0) Re: UT for below 8mm thk Tom Nelligan 16:54 Oct-27-2008 (0) Post a Followup: Name: E-Mail: Subject: Comments: ----------- Start Original Message ----------- : : hi, this is santhosh : : please tell me about UT for below 8mm thickness with reference code. thanks for reply. : As per AWS D 1.1 you cannot peform UT below 8mm thickness It require client acceptance and special calibration block required ------------ End Original Message ------------ Optional Link URL: Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP Page Title: is important! Optional Image URL: http://www....gif Attention! Please click the button only once. This may take a moment to process Forum Technical Discussions Help