Forum Technical Discussions      Re: UT for below 8mm thk Posted by: NEELA , E-mail: Address, on October 30, 2008 at 06:13 : In Reply to: Re: UT for below 8mm thk posted by : JK , E-mail: Address, on October 29, 2008 at 18:09 : Dear J.K. Please mention the code ,It will help forum member to discuss further Thanks ----------- Start Original Message ----------- : Hi, : Though there are some codes which allow UT to be carried out above 6 mm. : Using a 4Mhz transducer(8x9 mm) preferebly 70,80 degree krautkrammer probes & increasing the skip to 1-2 skip . : The best way to do is take a mock-up peice of the thickness of the weld you are going to test . A notch on the root and on the crown of the weld would be used as reference. : Anything more on this please contact me : Regards : J.K ------------ End Original Message ------------ Follow Ups: Post a Followup: Name: E-Mail: Subject: Comments: ----------- Start Original Message ----------- : Dear J.K. : Please mention the code ,It will help forum member to discuss further : Thanks : : Hi, : : Though there are some codes which allow UT to be carried out above 6 mm. : : Using a 4Mhz transducer(8x9 mm) preferebly 70,80 degree krautkrammer probes & increasing the skip to 1-2 skip . : : The best way to do is take a mock-up peice of the thickness of the weld you are going to test . A notch on the root and on the crown of the weld would be used as reference. : : Anything more on this please contact me : : Regards : : J.K ------------ End Original Message ------------ Optional Link URL: Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP Page Title: is important! Optional Image URL: http://www....gif Attention! Please click the button only once. This may take a moment to process Forum Technical Discussions Help