[ NDT-net Forum ]
[ Follow Ups ] [ Post Followup ] [ Help ]

---

NDT of heavy steel pates

Posted by: Tadeusz Stepinski , E-mail: ts@signal.uu.se, on May 13, 2000 at 10:49 :

Dear Colleagues,

For a customer in Scandinavia I am searching the equipment for the inspection of heavy steel plates (carbon steel, thickness 5 to 150 mm) in cold state after rolling. The equipment should be capable of detecting defects in the whole plate volume (plate width is up to 3 m). The inspection should be performed with a relatively high speed (up to 1 m/s).

Best regards

T. Stepinski

---

Follow Ups:

---

Post a Followup:

Name:
E-Mail:
Subject:

Comments:
: Dear Colleagues, : For a customer in Scandinavia I am searching the equipment for the inspection of heavy steel plates (carbon steel, thickness 5 to 150 mm) in cold state after rolling. The equipment should be capable of detecting defects in the whole plate volume (plate width is up to 3 m). The inspection should be performed with a relatively high speed (up to 1 m/s). : Best regards : T. Stepinski

Optional Link URL:	Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP
Link Title: is important!	Information on my Home Page
Optional Image URL:	http://www....gif

Attention! Please click the button only once. This may take a moment to process

---

[ NDT-net Forum ] [ Help ]