Forum Technical Discussions      Re: Calibration for stainless steel. Posted by: tj (PID_3627), E-mail: Address, on November 18, 2008 at 18:37 : In Reply to: Re: Calibration for stainless steel. posted by : Nigel Armstrong , E-mail: Address, on November 18, 2008 at 18:01 : ----------- Start Original Message ----------- Nathan I would have to agree with Nigel. If a technique must be made up for a job it is usually approved by a level 3 who has experience with the application. Letting mangement know that you are not sure about developing this technique is the right thing to do. They should know this already. Follow Ups: Post a Followup: Name: E-Mail: Subject: Comments: ----------- Start Original Message ----------- : Nathan : I would have to agree with Nigel. If a technique must be made up for a job it is usually approved by a level 3 who has experience with the application. Letting mangement know that you are not sure about developing this technique is the right thing to do. They should know this already. ------------ End Original Message ------------ Optional Link URL: Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP Page Title: is important! Optional Image URL: http://www....gif Attention! Please click the button only once. This may take a moment to process Forum Technical Discussions Help