Forum Technical Discussions      ASTM A578 Posted by: Theo Micottis , E-mail: Address, on November 21, 2008 at 18:08 : Hi everybody,I need some explanations about A578.I have had to check a bush with this dimensions: outer dia 600 inner 500. The clad surface was on the inner dia thickness 5mm. The acceptance level was S7. So I carried out examination from the clad surface as written in S7.1 using a MSEB 2 probe.The examination was carried out only to verify unbond.The final customer said me that I made the examination from the wrong side and also I used the wrong probe from the clad surface.Could someone help me to interpret this specification.THANK YOU Follow Ups: Re: ASTM A578 Nigel Armstrong 18:17 Nov-24-2008 (4) Re: ASTM A578 Theo Micottis 22:27 Nov-24-2008 (3) Re: ASTM A578 S.V.Swamy 10:21 Nov-25-2008 (2) Re: ASTM A578 Theo Micottis 19:22 Nov-25-2008 (0) Re: ASTM A578 Michel Couture 17:54 Nov-25-2008 (0) Re: ASTM A578 Nigel Armstrong 18:17 Nov-24-2008 (0) Post a Followup: Name: E-Mail: Subject: Comments: ----------- Start Original Message ----------- : Hi everybody,I need some explanations about A578.I have had to check a bush with this dimensions: outer dia 600 inner 500. The clad surface was on the inner dia thickness 5mm. The acceptance level was S7. So I carried out examination from the clad surface as written in S7.1 using a MSEB 2 probe.The examination was carried out only to verify unbond.The final customer said me that I made the examination from the wrong side and also I used the wrong probe from the clad surface.Could someone help me to interpret this specification.THANK YOU ------------ End Original Message ------------ Optional Link URL: Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP Page Title: is important! Optional Image URL: http://www....gif Attention! Please click the button only once. This may take a moment to process Forum Technical Discussions Help