Forum Technical Discussions      Re: Code Case 2235 examination volume Posted by: mj , E-mail: Address, on December 13, 2008 at 14:08 : In Reply to: Code Case 2235 examination volume posted by : David Mackintosh , E-mail: Address, on December 12, 2008 at 18:23 : Hello David, u are right most of the people not taking care the edge. also please note that we can cover entire volume with 2 pair TOFD probes. I did 100 mm thick CS sphere with 2 pair TOFD probes. We need to make a notch in the HAZ opposite side of the probes. if you will not get you have to go for 1 set of creeping probes for TOP surface and 1 set of 45% angle shear wave for back surface. Thanks MJ Follow Ups: Post a Followup: Name: E-Mail: Subject: Comments: ----------- Start Original Message ----------- : : Hello David, : u are right most of the people not taking care the edge. also please note that we can cover entire volume with 2 pair TOFD probes. I did 100 mm thick CS sphere with 2 pair TOFD probes. We need to make a notch in the HAZ opposite side of the probes. if you will not get you have to go for 1 set of creeping probes for TOP surface and 1 set of 45% angle shear wave for back surface. : Thanks : MJ : ------------ End Original Message ------------ Optional Link URL: Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP Page Title: is important! Optional Image URL: http://www....gif Attention! Please click the button only once. This may take a moment to process Forum Technical Discussions Help