Forum Technical Discussions      Re: penetrameter requirement Posted by: Michel Couture (PID_2805), E-mail: Address, on January 08, 2009 at 04:36 : In Reply to: penetrameter requirement posted by : susan , E-mail: Address, on January 08, 2009 at 00:50 : Hi Susan, From my experience when it comes to aircraft parts, the manufacturer i.e. Boeing, Airbus, Bombardier will have a specific procedure for you to follow. Having said that, if you are using other pennies then that specified in the procedure, you should request a deviation from the customer. I looked at ASTM E1025, but cobalt is not mentionned. Hope this will be of help. Michel ----------- Start Original Message ----------- : If I have a coblat material to x-ray but do not have any cobalt penes, is it acceptable to use Nickel penes? This is in regard to the aerospace industry. ------------ End Original Message ------------ Follow Ups: Post a Followup: Name: E-Mail: Subject: Comments: ----------- Start Original Message ----------- : Hi Susan, : From my experience when it comes to aircraft parts, the manufacturer i.e. Boeing, Airbus, Bombardier will have a specific procedure for you to follow. Having said that, if you are using other pennies then that specified in the procedure, you should request a deviation from the customer. I looked at ASTM E1025, but cobalt is not mentionned. Hope this will be of help. : Michel : : If I have a coblat material to x-ray but do not have any cobalt penes, is it acceptable to use Nickel penes? This is in regard to the aerospace industry. ------------ End Original Message ------------ Optional Link URL: Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP Page Title: is important! Optional Image URL: http://www....gif Attention! Please click the button only once. This may take a moment to process Forum Technical Discussions Help