Forum General Discussions      Re: Carbon Composite Calibration block Posted by: Joe Buckley    (PID_358), E-mail: Address, on November 25, 2008 at 21:26 : In Reply to: Carbon Composite Calibration block posted by : Godfrey Hands , E-mail: Address, on November 25, 2008 at 14:59 : NDT Engineering used to supply these and, I believe, used to make them for a lot of the aircraft companies. Now they are part of Olympus I don't have anything to do with them, But assuming its the same people making them they should be worth trying. Joe ----------- Start Original Message ----------- : Hi, : I am looking for a source of Carbon Composite Thickness calibration blocks or step wedges. : Who markets these? Who manufactures them? : Godfrey ------------ End Original Message ------------ Follow Ups: Post a Followup: Name: E-Mail: Subject: Comments: ----------- Start Original Message ----------- : NDT Engineering used to supply these and, I believe, used to make them for a lot of the aircraft companies. : Now they are part of Olympus I don't have anything to do with them, But assuming its the same people making them they should be worth trying. : Joe : : Hi, : : I am looking for a source of Carbon Composite Thickness calibration blocks or step wedges. : : Who markets these? Who manufactures them? : : Godfrey ------------ End Original Message ------------ Optional Link URL: Example: "http://www....html". Alternative write "http://www.ndt.net/wshop/attach/filename.htm" if you transfered a filename.htm via FTP Page Title: is important! Optional Image URL: http://www....gif Attention! Please click the button only once. This may take a moment to process Forum General Discussions Help