where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -
734 views
Technical Discussions
Ali Chaboki
Engineering, NDT, Welding
TUV NORD, Iran, Joined May 2013, 32

Ali Chaboki

Engineering, NDT, Welding
TUV NORD,
Iran,
Joined May 2013
32
21:05 Aug-19-2013
Corrosion survay with TOFD

Dear specialists
I want to know is there any diference in sett up configuration of TOFD exam when inspection have to be done to look for corrosion in the region just under and in vicinity of the welds? where it should be focused in this condition?
welds are in dubble V and are on pressure vessels with various thiknesses of 20mm up to 80mm.
do offset scanning is needed?
I appreciate your response in advance.
Ali

 
 Reply 
 
MAL
United Kingdom, Joined Jun 2012, 14

MAL

United Kingdom,
Joined Jun 2012
14
10:08 Aug-21-2013
Re: Corrosion survay with TOFD
In Reply to Ali Chaboki at 21:05 Aug-19-2013 (Opening).

If you are looking for erosion or corosion on the back wall (inside surface) You should focus just above that area not at 2 \3 . This will improve your sensitivity in the area of concern. The 80mm would benefir from 2 scans offset as it has a deep wide area of concern

 
 Reply 
 

Product Spotlight

A1525 SOLO

A1525 Solo – the most compact and affordable TMF unit with two phased array transducers and 3D v
...
isualization and analysis software in standard delivery set. A compact, ergonomic and easy to handheld Phased Array unit based on Total Focusing Method for easy-going imaging of inspection objects with two-dimensional and three-dimensional visualization and evaluation of inspection results.
>

UCI Hardness Tester NOVOTEST T-U2

UCI hardness tester NOVOTEST T-U2 is is used for non-destructive hardness testing of: metals and
...
alloys by scales of hardness: Rockwell (HRC), Brinell (HB), Vickers (HV); non-ferrous metals, alloys of iron etc., and using five additional scales for calibration; with tensile strength (Rm) scale determines the tensile strength of carbon steel pearlitic products by automatic recalculation from Brinell (HB) hardness scale.
>

Combination of Digital Image Correlation and Thermographic Measurements

The combination of measuring results from the digital image correlation (ARAMIS, DIC) and temperat
...
ure measuring data from infrared cameras permits the simultaneous analysis of the thermal and mechanical behavior of test specimens in the materials and components testing field.
>

IRIS 9000Plus - Introducing the next generation of heat exchanger inspection.

Representing the seventh generation of the IRIS system, the IRIS 9000 Plus has nearly 200 years of c
...
ombined field inspection experience incorporated in its design. This experience combined with a strong commitment to quality and a history of innovation has made Iris Inspection Services® the undisputed leader in IRIS technology.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window