The Largest Open Access Portal of Nondestructive Testing (NDT)

10:35 Apr-23-2019
SDH EQUIVALENCE

I am looking for a table of db change for different diameters SDH. 1, 2, 2.5 and 3 mm.
Thanks

10:54 Apr-23-2019
Re: SDH EQUIVALENCE

Hi,

this may help you.

https://www.ndt.net/article/v07n01/ginzel/ginzel.htm

11:44 Apr-23-2019
Re: SDH EQUIVALENCE

Reading your request I First thought: Typical question to be answered in the famous Josef Krautkramer - Book "Ultrasonic Testing of Materials" He had put some nice graphics and thumb rules in his book, which I always used in my UT-Lessons.

Next - reading the link to this older post of Ed. Ginzel referencing Ermolov made me think: You should use CIVA simulation software to get the full insight into this topic.

But you may simply follow the link to the page of the CIVA makers EXTENDE:
Here you find lot of stuff:
http://www.extende.com/ultrasound-calibration-defects
http://www.extende.com/ut-sdh-side-drilled-holes-at-different-depths-and-contact-probes
http://www.extende.com/ut-sdh-side-drilled-holes-at-different-depths-and-immersion-probes
http://www.extende.com/comparison-fbh-sdh

It is not easy to access those pages just directly from the EXTENDE Homepage (http://www.extende.com/) but if you look for the sitemap (http://www.extende.com/site-map) you may have a view about all the helpful information they offer under the headline "Experimental validation of models in UT"