where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -

Iris Inspection Services, Inc.
We are the world's largest supplier of air cooler, boiler and exchanger tubing inspection services.
639 views
Technical Discussions
wang
wang
07:54 Aug-25-2008
who can tell me this formula's unit?

who can tell me this formula's unit?
N=V/£¨15.16F sin2(¦Ã)), { british standard [BS EN 12668-2:2001]}
N:nearfied length unit=?
V:sound velocity of the circular transducer unit=?
¦Ã:divergence unit=?
F:centre frequency unit=?
15.16: ?



 
 Reply 
 
Navita
Navita
00:32 Aug-25-2008
Re: who can tell me this formula's unit?
All dimensions for calculation are in mm for length/ distance, Hz for frequency and seconds for time.

----------- Start Original Message -----------
: who can tell me this formula's unit?
: N=V/£¨15.16F sin2(¦Ã)), { british standard [BS EN 12668-2:2001]}
: N:nearfied length unit=?
: V:sound velocity of the circular transducer unit=?
: ¦Ã:divergence unit=?
: F:centre frequency unit=?
: 15.16: ?
------------ End Original Message ------------




 
 Reply 
 
Udo Schlengermann
Consultant, -
Standards Consulting, Germany, Joined Nov 1998, 179

Udo Schlengermann

Consultant, -
Standards Consulting,
Germany,
Joined Nov 1998
179
06:27 Aug-25-2008
Re: who can tell me this formula's unit?
The explanations by Navita on equation A.1 of European Standard EN 12668-2 are correct.

If you use mm/s for velocity and cycles/s = Hz for frequency you get mm for the near field length. The factor 15.16 and sin2(gamma) are dimensionless.

Please note, that the velocity of the block is addressed, not the velocity of the transducer.

Udo Schlengermann
Convener CEN/TC138/WG2

----------- Start Original Message -----------
: who can tell me this formula's unit?
: N=V/£¨15.16F sin2(¦Ã)), { british standard [BS EN 12668-2:2001]}
: N:nearfied length unit=?
: V:sound velocity of the circular transducer unit=?
: ¦Ã:divergence unit=?
: F:centre frequency unit=?
: 15.16: ?
------------ End Original Message ------------




 
 Reply 
 

Product Spotlight

FMC/TFM

Next generation for Phased Array UT is here now with FMC/TFM! Have higher resolution imaging, impr
...
oved signal to noise ratio, characterize, size and analyze defects better with access to several wave mode views and save raw FMC data for higher quality analysis.  Some of the benefits are:
  • Beautiful Image! Easier to understand what you're looking at
  • Completely focused in entire image or volume
  • Much easier to define setups before inspection
  • Easier to decipher geometry echoes from real defects
  • Oriented defects (e.g. cracks) are imaged better
  • See image from different wave modes from one FMC inspection
  • FMC data can be reprocessed/analyzed without going back to the field
>

NDT.net launches mobile-friendly design

NDT.net has revamped its website providing a mobile-friendly design.The front page received a comp
...
letely new design and all other sections are now reacting responsively on mobile devices. This has been a major step to make our website more user- friendly.
>

ISAFE3 Intrinsically Safe Sensor System

ISAFE3 intrinsically safe sensor system of Vallen Systeme is especially targeted at the petrochemica
...
l - as well as oil and gas transportation industry. The sensor system is designed for permanent monitoring or periodic inspection tasks. Sensors are available for different AE-frequency ranges optimized for corrosion and fatigue crack detection and other applications. The ISAFE 3 sensor system consists of an AE-sensor (model ISAS3) certified according to ATEX/IEC for installation in zone 0, gas group IIC, IP68, 20 to +60 °C, and a signal isolator (model SISO3) certified for installation in zone 2. An ISAS3 sensor can be mounted in atmosphere or submerged, e.g. in water or crude oil. It is supported by mounting tools for temporary (magnets) or permanent (welded) installation. ISAFE3 supports automatic sensor coupling test and can be used with any AE signal processor supporting 28V supply at 90 mA peak, e.g. Vallen Systeme ASIP-2/A.
>

ISONIC 3510

Very Powerful Superior Performance Extremely Portable Smart Phased Array Ultrasonic Flaw Detector an
...
d Recorder with 2 Conventional UT and TOFD Channels uniquely combines PA, single- and multi-channel conventional UT, and TOFD modalities providing 100% raw data recording and imaging. Suitable for all kinds of every-day ultrasonic inspections
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window