where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -

2673 views
Technical Discussions
ashraf samir
NDT Inspector
petrojet, Egypt, Joined Apr 2001, 2

ashraf samir

NDT Inspector
petrojet,
Egypt,
Joined Apr 2001
2
01:39 Apr-29-2001
what is lack of cross penetration lack of inter-run fusion

what is lack of inter-run fusion and lack of cross penetration in semi auto GTAW , what is the difference between it and cold lap and lack of side wall fushion .


 
 Reply 
 
Anonymous
Anonymous
03:37 Apr-29-2001
Re: what is lack of cross penetration lack of inter-run fusion
: what is lack of inter-run fusion and lack of cross penetration in semi auto GTAW , what is the difference between it and cold lap and lack of side wall fushion .
.
Sorry, I first posted this under the wrong subject. However, the main difference between inter-run fusuion, lack of cross penetration, cold lap and side wall fusion is "location in the weld". Lack of cross pen occurs when welding the root internally and the hot pass externally. If you do not get adequate penetration with your hot pass, you will get lack of cross penetration. Cold lap, side wall and inter-run fusion occur from inadequate heat input or improper welding technique.


 
 Reply 
 

Product Spotlight

FD800 Bench Top Flaw Detectors

The bench-top FD800 flaw detector range combines state-of-the-art flaw detection with advanced mater
...
ial thickness capabilities. Designed for use in the laboratory these gauges are the tool you need for all your flaw detecting needs.
>

PAUT Probes

Typical Phased Array probes have frequencies between 1MHz and 20MHz and the number of wafers is 10
...
to 128. M2 Electronics offers customers conventionally ultrasound probes and the ability to provide high-precision Phased Array Ultrasound Probes of up to 256 wafers. We can also customize the probe for our customers to meet the specific application requirements of the user.
>

MANTIS

MANTIS is a compact, powerful and affordable flaw detector (16:64PR), dedicated to field operators
...
. This portable equipment offers standard (electronic-, sector-, compound scan, conventional UT for pulse-echo, dual array and TOFD inspections), and advanced phased-array (real-time TFM -Total Focusing Method). MANTIS benefits from the same intuitive and user-friendly interface (CAPTURE) than Gekko for easier inspections.
>

ISAFE3 Intrinsically Safe Sensor System

ISAFE3 intrinsically safe sensor system of Vallen Systeme is especially targeted at the petrochemica
...
l - as well as oil and gas transportation industry. The sensor system is designed for permanent monitoring or periodic inspection tasks. Sensors are available for different AE-frequency ranges optimized for corrosion and fatigue crack detection and other applications. The ISAFE 3 sensor system consists of an AE-sensor (model ISAS3) certified according to ATEX/IEC for installation in zone 0, gas group IIC, IP68, 20 to +60 °C, and a signal isolator (model SISO3) certified for installation in zone 2. An ISAS3 sensor can be mounted in atmosphere or submerged, e.g. in water or crude oil. It is supported by mounting tools for temporary (magnets) or permanent (welded) installation. ISAFE3 supports automatic sensor coupling test and can be used with any AE signal processor supporting 28V supply at 90 mA peak, e.g. Vallen Systeme ASIP-2/A.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window