where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -

DASEL SISTEMAS
Our Phased Array equipments, based on SITAU Technology, are among the PAS highest performance in the market.
1584 views
Technical Discussions
Dipl-Ing. Christoph Müller
Consultant, Process Validation
Austria, Joined May 2001, 1

Dipl-Ing. Christoph Müller

Consultant, Process Validation
Austria,
Joined May 2001
1
05:23 May-09-2001
Bubble detection in high-viscous gel

We have the problem of air bubbles in a high-viscous gel used for in-vitro diagnostics. The gel is under pressure and flowing very slowly through a metallic pipe of about 30 mm in diameter.

Is there a possibility to detect these air bubbles with ultrasonic-equipment. Asking for help/contacts.

Christoph Müller


 
 Reply 
 
Tom Nelligan
Engineering,
retired, USA, Joined Nov 1998, 390

Tom Nelligan

Engineering,
retired,
USA,
Joined Nov 1998
390
05:37 May-09-2001
Re: Bubble detection in high-viscous gel
: We have the problem of air bubbles in a high-viscous gel used for in-vitro diagnostics. The gel is under pressure and flowing very slowly through a metallic pipe of about 30 mm in diameter.
.
: Is there a possibility to detect these air bubbles with ultrasonic-equipment. Asking for help/contacts.

You didn't indicate the size of the bubbles, but assuming that they are on the order of one-half millimeter in diameter or larger, it should be possible to detect them with conventional ultrasinic equipment. However, assuming also that they may occur anywhere in the 30 mm diameter stream, it will be necessary to use a number of transducers and multiple instrumentation channels to comprehensively inspect 100% of the gel volume. So yes, your proposed test is probably possible with a multi-channel system.

The Panametrics affiliate in Austria is Panametrics Messtechnik GmbH. You will find a link to them on our home page at .

--Tom Nelligan



 
 Reply 
 
Dr. Patel
R & D, Consultant to Universities/Industries
Fallon Ultrasonics/McMaster University, Canada, Joined May 2001, 20

Dr. Patel

R & D, Consultant to Universities/Industries
Fallon Ultrasonics/McMaster University,
Canada,
Joined May 2001
20
06:10 May-09-2001
Re: Bubble detection in high-viscous gel
: We have the problem of air bubbles in a high-viscous gel used for in-vitro diagnostics. The gel is under pressure and flowing very slowly through a metallic pipe of about 30 mm in diameter.
.
: Is there a possibility to detect these air bubbles with ultrasonic-equipment. Asking for help/contacts.
.
: Christoph Müller
.We have sold the system to many univeristy where they are studying air bubbles and particles. The frequency selection is important. Yes they are measuring both the number of particles and also tracking the particles within the beam of transducer. The software comes with the system and some other group has also tried in latex materials. Thus, it is possible with single channel or dual channel system. One can measure the attenuation and velocity and second channel will measure the counts of particles within the selected region and track the particles. We need following information
1. What is the attenuation in the gel
2. The bubble size
3. This allow us to configure the system power and sensor frequency

Regards

Dr. Patel



 
 Reply 
 
Wieslaw Bicz
Engineering,
PBP Optel sp. z o.o., Poland, Joined Feb 2009, 265

Wieslaw Bicz

Engineering,
PBP Optel sp. z o.o.,
Poland,
Joined Feb 2009
265
07:13 May-09-2001
Re: Bubble detection in high-viscous gel
: We have the problem of air bubbles in a high-viscous gel used for in-vitro diagnostics. The gel is under pressure and flowing very slowly through a metallic pipe of about 30 mm in diameter.
.
: Is there a possibility to detect these air bubbles with ultrasonic-equipment. Asking for help/contacts.
.
: Christoph Müller
.
May be it would be better to remove this bubbles. In this case it would be possible to do it with ultrasound and it could be very effective.
If you are interested, we can help in implementing this solution.


 
 Reply 
 
jean paul van Cuyck
Director
A2MS, Applied Acoustics, Materials and Systems, France, Joined Nov 1998, 13

jean paul van Cuyck

Director
A2MS, Applied Acoustics, Materials and Systems,
France,
Joined Nov 1998
13
04:07 May-10-2001
Re: Bubble detection in high-viscous gel
: We have the problem of air bubbles in a high-viscous gel used for in-vitro diagnostics. The gel is under pressure and flowing very slowly through a metallic pipe of about 30 mm in diameter.
.
: Is there a possibility to detect these air bubbles with ultrasonic-equipment. Asking for help/contacts.
.
: Christoph Müller
.

Conceptually yes.

In fact the aim problem is to find the compromise between the buble size, frequency resolution and sound attenuation.
You can even try to use the buble resonance frequency. It depend on the medium and the viscosity.

I have worked on the sound propagation through particle cloud (buble, plankton, mineral particle).
I could help you if you need.


 
 Reply 
 

Product Spotlight

Teletest Focus+

Teletest Focus+ electronics have superior capabilities than rivals on the market. Beyond the usual
...
test features, Focus+ has 24 transmit channels and 24 receive channels, with an additional on-board switching capabilities. The instrument's frequency range is 10–300 kHz.
>

A1525 SOLO

A1525 Solo – the most compact and affordable TMF unit with two phased array transducers and 3D v
...
isualization and analysis software in standard delivery set. A compact, ergonomic and easy to handheld Phased Array unit based on Total Focusing Method for easy-going imaging of inspection objects with two-dimensional and three-dimensional visualization and evaluation of inspection results.
>

UCI Hardness Tester NOVOTEST T-U2

UCI hardness tester NOVOTEST T-U2 is is used for non-destructive hardness testing of: metals and
...
alloys by scales of hardness: Rockwell (HRC), Brinell (HB), Vickers (HV); non-ferrous metals, alloys of iron etc., and using five additional scales for calibration; with tensile strength (Rm) scale determines the tensile strength of carbon steel pearlitic products by automatic recalculation from Brinell (HB) hardness scale.
>

GEKKO - Portable Phased Array Testing with TFM in Real-Time

The portable phased array testing system GEKKO provides 64 parallel test channels. On creating testi
...
ng parameters the operator is assisted by the CIVA software. Due to its modular set-up the GEKKO instrument is suitable for operators of all skill levels.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window