where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -
454 views
Technical Discussions
Jaeseok Park
R & D,
DOOSAN, South Korea, Joined Jun 2009, 10

Jaeseok Park

R & D,
DOOSAN,
South Korea,
Joined Jun 2009
10
03:45 Jun-09-2009
EN 1712

It is hard to understand some part of EN1712, please give me a hand :-)

1. Clause 3.4 describes evaluation levels for each methods suggested in clause 3.2, but method 3. What would be the evaluation level for method 3?

2. According to clause 3.5 and figure A.1, the recording levels for method 1 are ‘reference level -2dB’ or ‘reference level - 6dB’. And, the acceptance levels are given by table A.1 and figure A.1. If the indication has peak amplitude of ‘reference level -6dB’ and length of 1.5T. This indication is not the subject of recording but not-acceptable indication. Is it correct?

3. At 3rd paragraph of clause 4.1, it is stated that any planar indication is not acceptable. Is this statement goes well with the acceptance criteria suggested table A1/A2 and figure A1/A2?

Thank you.

 
 Reply 
 

Product Spotlight

Compact NDT inspection-heads for measurements with active thermography

The compact inspection head is suitable for thermographic ndt tasks. The uncooled infrared camera
...
is specially developed for NDI-tasks and offers a thermal sensitivity until now known only from thermal imagers with cooled detector. All required components and functions are integrated into the inspection-head. You will only need an ethernet cable to connect the sensor with the evaluation system.
>

UCI Hardness Tester NOVOTEST T-U2

UCI hardness tester NOVOTEST T-U2 is is used for non-destructive hardness testing of: metals and
...
alloys by scales of hardness: Rockwell (HRC), Brinell (HB), Vickers (HV); non-ferrous metals, alloys of iron etc., and using five additional scales for calibration; with tensile strength (Rm) scale determines the tensile strength of carbon steel pearlitic products by automatic recalculation from Brinell (HB) hardness scale.
>

Ultrasonic Probe Recharacterization Service

NDT Systems offers a comprehensive Aftercare and Recharacterization Service for all our ultrasonic
...
probes. The Recharacterization Service is fully compliant with International ASTM E1065 Standard Guide (and other applicable standards) and offers complete documentation, traceable to the ASTM E1065 Standard. For more details or to schedule Recharacterization Services contact ndtsales@ndtsystems.com
>

OmniScan™ X3 flaw detector

The OmniScan X3 flaw detector is a complete phased array toolbox. Powerful tools, like total focus
...
ing method (TFM) images and advanced visualization capabilities, enable you to complete your inspection with greater confidence.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window