where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -

NDTSS - Non Destructive Testing Society of Singapore
Visit us at SINCE 2019
543 views
Technical Discussions
Sam
Sam
18:38 Jul-03-2009
Coating damage assessment of buried pipeline

Any sugggestions to assess the extend of exteranl coating damage or external corrosion on a burried pipeline (let us say for 24"line). We are not concerned about any internal corrosion.
Thanks
Sam

 
 Reply 
 
Creed
NDT Inspector,
n.n., Joined Jul 2009, 28

Creed

NDT Inspector,
n.n.,
Joined Jul 2009
28
06:43 Jul-08-2009
Re: Coating damage assessment of buried pipeline
In Reply to Sam at 18:38 Jul-03-2009 (Opening).

Why dont you try DCVG to inspect the external coating for burried pipeline?

 
 Reply 
 
Ahmad Sawalha
Ahmad Sawalha
18:16 Jul-15-2009
Re: Coating damage assessment of buried pipeline
In Reply to Creed at 06:43 Jul-08-2009 .

Dear sam,
you can try guided wave or corrosion scan, but first you need to do an economical study for cause this technology is very expensive

regards
ahmad sawalha
inspection engineer
JBC

 
 Reply 
 

Product Spotlight

NDT Master Lecturer

In the program both university professors and practitioners will give lectures, which guarantees the
...
oretical depth and practical inside. Academic Director: Prof. Dr. Christian Boller
The following lecturers are not complete: Prof. Tadeusz Stepinski, Prof. Wieslaw Staszewski, Prof. Frank Walther, Prof. Giovanni Bruno, Prof. Gerd Dobmann, Prof. Philippe Guy
>

FMC/TFM

Next generation for Phased Array UT is here now with FMC/TFM! Have higher resolution imaging, impr
...
oved signal to noise ratio, characterize, size and analyze defects better with access to several wave mode views and save raw FMC data for higher quality analysis.  Some of the benefits are:
  • Beautiful Image! Easier to understand what you're looking at
  • Completely focused in entire image or volume
  • Much easier to define setups before inspection
  • Easier to decipher geometry echoes from real defects
  • Oriented defects (e.g. cracks) are imaged better
  • See image from different wave modes from one FMC inspection
  • FMC data can be reprocessed/analyzed without going back to the field
>

YXLON Cougar EVO

Scalable small footprint X-ray inspection systems for assembly and laboratory applications. The
...
YXLON Cougar EVO series was designed to provide the "best-in- class" inspection solutions for SMT, semiconductor, and laboratory assembly applications, while maintaining a small system footprint for maximum convenience. With optimized software and hardware, these systems produce higher quality and more consistent results than other electronics inspection systems currently on the market.
>

Sci Aps Z-Series Portable Handheld Analysers

The world’s only handheld analyzer that measures carbon content in stainless (yes even L-grades),s
...
teels, and cast irons. Also accepted for low Si analysis for sulfidic corrosion analysis, and is widely used in the power industry for Cr analysis, for flow accelerated corrosion applications.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window