- since 1996 -
UCI Hardness Tester NOVOTEST T-U2
UCI hardness tester NOVOTEST T-U2 is is used for non-destructive hardness testing of: metals and
alloys by scales of hardness: Rockwell (HRC), Brinell (HB), Vickers (HV); non-ferrous metals, alloys of iron etc., and using five additional scales for calibration; with tensile strength (Rm) scale determines the tensile strength of carbon steel pearlitic products by automatic recalculation from Brinell (HB) hardness scale.
High-performance Linear Phased Array Probes
Available to order from stock in a range of 5MHz – 7.5MHz and from 16 to 64 elements. Designed w
ith piezo-composite elements, Phoenix phased array probes provide high-resolution imaging to maximise sensitivity; accurate ultrasonic detection and sizing of defects in welds; and effective corrosion mapping. Housed in a rugged stainless steel case for on-site industrial NDT applications.
nanoVoxel series has nano-scale resolution upto 500nm by using high voltage X-ray source (from 80-
300 kV) with micro/nano focal spot and highly sensitive flat panel detectors and unique Optical coupling detector.
Echomac® PA Bar Tester
The Echomac® PA BT provides 100% inspection of round bars for core and surface defects, at speeds u
p to 2 m/sec, depending on the specific application. The unit allows producers to handle a much larger range of diameters in one installation, and is available in 3 models to test 10 – 75mm diameter (small model); 20 – 130mm (medium model) or 50 – 254mm (large model) bars.