The Largest Open Access Portal of Nondestructive Testing (NDT)

626 views Technical Discussions Richard D. Roberts Engineering, Executive Managment Quest Integrity Group, USA, Joined Nov 1998, 78 Richard D. Roberts Engineering, Executive Managment Quest Integrity Group, USA, Joined Nov 1998 78 06:27 Jan-09-2003 Platform Heater Tube Inspection I am in search of proven NDT techniques to test/inspect tubes in platform heater coils. These vertically orientated coils are "U" shaped with two headers (inlet/outlet) connected to each end. The horizontal orientated Headers are approximately 30' long with around 30 "U" shaped coils distributed down the axis. The material is susceptible to creep damage. Any recommendations on inspection techniques and experiences would be appreciated. Regards, Rich Roberts QUEST Integrated, Inc.    Reply  Translate  Close   Mike Trinidad Consultant, LMATS Pty Ltd , Australia, Joined Jan 2003, 141 Mike Trinidad Consultant, LMATS Pty Ltd , Australia, Joined Jan 2003 141 03:22 Jan-13-2003 Re: Platform Heater Tube Inspection You could try the long range ultrasonic systems such as Teletest. I know Plant Integrity in the UK has had experience with this type of inspection. The person to talk to is Peter Mudge peter.mudge@twi.co.uk Kindest Regards Mike Trinidad Teletest home page    Reply  Translate  Close

Product Spotlight Ultrasonic Squirter/Gantry System StandTecScan Systems TecScan’s NDT Ultrasonic Gantry Systems are industrial Squirter scanners designed for non-destru ... ctive quality testing and raster scanning of large structures and parts. The Gantry Systems are usually composed of an Industrial Mechanical Scanner and a Control Room with System Workstation. > 5 Showcases4 Videos FMC/TFM StandAdvanced OEM Solutions Next generation for Phased Array UT is here now with FMC/TFM! Have higher resolution imaging, impr ... oved signal to noise ratio, characterize, size and analyze defects better with access to several wave mode views and save raw FMC data for higher quality analysis.  Some of the benefits are: Beautiful Image! Easier to understand what you're looking at Completely focused in entire image or volume Much easier to define setups before inspection Easier to decipher geometry echoes from real defects Oriented defects (e.g. cracks) are imaged better See image from different wave modes from one FMC inspection FMC data can be reprocessed/analyzed without going back to the field > 3 Showcases High-performance Linear Phased Array Probes StandPhoenix Inspection Systems Limited Available to order from stock in a range of 5MHz – 7.5MHz and from 16 to 64 elements. Designed w ... ith piezo-composite elements, Phoenix phased array probes provide high-resolution imaging to maximise sensitivity; accurate ultrasonic detection and sizing of defects in welds; and effective corrosion mapping. Housed in a rugged stainless steel case for on-site industrial NDT applications. > 5 Showcases5 Videos NDT Master Lecturer StandNDT Master In the program both university professors and practitioners will give lectures, which guarantees the ... oretical depth and practical inside. Academic Director: Prof. Dr. Christian Boller The following lecturers are not complete: Prof. Tadeusz Stepinski, Prof. Wieslaw Staszewski, Prof. Frank Walther, Prof. Giovanni Bruno, Prof. Gerd Dobmann, Prof. Philippe Guy > 5 Showcases more Showcases

Share...

• Home
• Exhibition
• Archive
• Forum
• Jobs
• Members
• Events
• Directory
• NDT A-Z

• Advertise
• Privacy Policy
• Contact & Imprint
• About

© NDT.net - Where expertise comes together. The Largest Open Access Portal of Nondestructive Testing (NDT)- since 1996