- since 1996 -
Very Powerful Superior Performance Extremely Portable Smart Phased Array Ultrasonic Flaw Detector an
d Recorder with 2 Conventional UT and TOFD Channels uniquely combines PA, single- and multi-channel conventional UT, and TOFD modalities providing 100% raw data recording and imaging. Suitable for all kinds of every-day ultrasonic inspections
OmniScan™ X3 flaw detector
The OmniScan X3 flaw detector is a complete phased array toolbox. Powerful tools, like total focus
ing method (TFM) images and advanced visualization capabilities, enable you to complete your inspection with greater confidence.
Research Center IDEKO develops an ultrasonic train wheel inspection system for CAF
The Basque Research centre IK4-IDEKO has developed a state-of-the-art ultrasonic inspection system f
or the train wheel. This system secures a sound condition of train wheels and is thus a significant contribution to rail transport safety. The device was delivered to CAF recently and its use allows the manufacturer to become an approved supplier of rolling stock in Italy, as it meets the demanding homologation standards of this country. \\\\r\\\\n
Extended Range Variable Wall® Piping Calibration Blocks for Longseam Inspection
This set of two blocks has been specially designed for situations where ultrasonic examination tak
es place circumferentially or “around the curve” for applications such as inspection of longseam welds in piping and vessels. Jointly designed by PH Tool and Holloway NDT, the blocks feature side-drilled hole reflectors positioned within novel compound-curves, each with multiple thickness steps. The unique design results in a light and compact form factor, with the largest block weighing just over 15 lbs and spanning just 16 ¾”. Coverage is provided for nominal pipe sizes from 6” to 10” in the small block and 12” to a whopping 56” in the large block. The compound OD curves and multiple wall thicknesses actually exceed ASME requirements, providing exceptional signal response and measurement accuracy. Properly managing beam divergence off the ID and stabilizing beam skew due to probe rocking is essential to maintaining a consistent calibration when inspecting lengthwise on curved surfaces.