- since 1996 -
SONOAIR - air-coupled Phased Array Ultrasonic Inspection System
For highly attenuating materials, the performance of the system is critical. The ultrasonic sensors,
the scanning area and the system settings should be flexibly adapted to the test task and the material. These high expectations are met with the new and modular testing system SONOAIR. With the world’s first air-coupled phased-array UT inspection system SONOAIR we developed a technology that works with up to 4 transmitter and receiver channels with freely configurable square wave burst transmitters as wells as low noise receiving amplifiers.
High-performance Linear Phased Array Probes
Available to order from stock in a range of 5MHz – 7.5MHz and from 16 to 64 elements. Designed w
ith piezo-composite elements, Phoenix phased array probes provide high-resolution imaging to maximise sensitivity; accurate ultrasonic detection and sizing of defects in welds; and effective corrosion mapping. Housed in a rugged stainless steel case for on-site industrial NDT applications.
FD800 Bench Top Flaw Detectors
The bench-top FD800 flaw detector range combines state-of-the-art flaw detection with advanced mater
ial thickness capabilities. Designed for use in the laboratory these gauges are the tool you need for all your flaw detecting needs.
Sci Aps Z-Series Portable Handheld Analysers
The world’s only handheld analyzer that measures carbon content in stainless (yes even L-grades),s
teels, and cast irons. Also accepted for low Si analysis for sulfidic corrosion analysis, and is widely used in the power industry for Cr analysis, for flow accelerated corrosion applications.