where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -
355 views
Technical Discussions
John
John
04:31 Mar-25-2004
ASME Cal Blocks

When would you use the 2% notches on the ASME cal blocks? Are they there for comparing to undercut signals?

Is there ever a time when they are used when constructing the DAC?

John


 
 Reply 
 
Ed T.
Ed T.
08:37 Mar-25-2004
Re: ASME Cal Blocks
----------- Start Original Message -----------
: When would you use the 2% notches on the ASME cal blocks? Are they there for comparing to undercut signals?
: Is there ever a time when they are used when constructing the DAC?
: John
------------ End Original Message ------------

According to ASME Sec. V 2000, Articles, 4 & 5, 2% notches are used for vessel examinations. Side drilled holes are generally used for DAC construction for vessel calibrations with the notch location and amplitudes marked on the screen.
ASME Sec. V, Article 4, B-465 discusses the amplitude responses from square notches at the opposite side of the block from various angles. B465.2 states that a 45º shear wave angle may give you an indication of 2-1 above DAC on a square notch, whereas a 60 º may give you an indication of only ½ DAC and that indication from that notch shall be considered when evaluating reflectors at the opposite surface.
Notches are used for calibration of piping and tubing materials. Now depending on which article you are using, whether it is Article 4 or Article 5, the notch sizes vary and will be used for DAC construction. Side drilled holes may be used provided you can demonstrate equivalent or greater sensitivity than that produced by notches.
Article 4, requires notches to be between 8%t and 11%t. Article 5 requires notches to be 5%t or 0.004”, whichever is greater.



 
 Reply 
 

Product Spotlight

Teletest Focus+

Teletest Focus+ electronics have superior capabilities than rivals on the market. Beyond the usual
...
test features, Focus+ has 24 transmit channels and 24 receive channels, with an additional on-board switching capabilities. The instrument's frequency range is 10–300 kHz.
>

Compact NDT inspection-heads for measurements with active thermography

The compact inspection head is suitable for thermographic ndt tasks. The uncooled infrared camera
...
is specially developed for NDI-tasks and offers a thermal sensitivity until now known only from thermal imagers with cooled detector. All required components and functions are integrated into the inspection-head. You will only need an ethernet cable to connect the sensor with the evaluation system.
>

Ultrasonic Testing Immersion Tanks with Unmatched Scanning Features

TecScan’s non-destructive testing Ultrasonic Immersion Tanks & scanners are designed for high pe
...
rformance and demanding NDT testing applications. Our Scan3D™ line of High Precision Immersion Tanks are specifically designed for automated ultrasonic testing of complex composites parts used in aerospace and industrial applications.
>

MUSE Mobile Ultrasonic Equipment

The MUSE, a portable ultrasonic imaging system, was developed for in-field inspections of light-weig
...
ht structures. The MUSE consists of a motor-driven manipulator, a water circulation system for the acoustic coupling and a portable ultrasonic flaw detector (USPC 3010). The MUSE provides images of internal defects (A-, B-,C- and D-scan).
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window