where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -

396 views
Technical Discussions
John
John
04:31 Mar-25-2004
ASME Cal Blocks

When would you use the 2% notches on the ASME cal blocks? Are they there for comparing to undercut signals?

Is there ever a time when they are used when constructing the DAC?

John


 
 Reply 
 
Ed T.
Ed T.
08:37 Mar-25-2004
Re: ASME Cal Blocks
----------- Start Original Message -----------
: When would you use the 2% notches on the ASME cal blocks? Are they there for comparing to undercut signals?
: Is there ever a time when they are used when constructing the DAC?
: John
------------ End Original Message ------------

According to ASME Sec. V 2000, Articles, 4 & 5, 2% notches are used for vessel examinations. Side drilled holes are generally used for DAC construction for vessel calibrations with the notch location and amplitudes marked on the screen.
ASME Sec. V, Article 4, B-465 discusses the amplitude responses from square notches at the opposite side of the block from various angles. B465.2 states that a 45º shear wave angle may give you an indication of 2-1 above DAC on a square notch, whereas a 60 º may give you an indication of only ½ DAC and that indication from that notch shall be considered when evaluating reflectors at the opposite surface.
Notches are used for calibration of piping and tubing materials. Now depending on which article you are using, whether it is Article 4 or Article 5, the notch sizes vary and will be used for DAC construction. Side drilled holes may be used provided you can demonstrate equivalent or greater sensitivity than that produced by notches.
Article 4, requires notches to be between 8%t and 11%t. Article 5 requires notches to be 5%t or 0.004”, whichever is greater.



 
 Reply 
 

Product Spotlight

Ultrasonic Squirter/Gantry System

TecScan’s NDT Ultrasonic Gantry Systems are industrial Squirter scanners designed for non-destru
...
ctive quality testing and raster scanning of large structures and parts. The Gantry Systems are usually composed of an Industrial Mechanical Scanner and a Control Room with System Workstation.
>

OPBOX with standard software is able to do all types of inspections and measurements: flaw detection in welds and materials, scanning of objects, testing composite materials, forged and moulded pieces, many UT inspections, measurements of properties of ma

Typical applications: UT measurements with pulse technique, Measurement of thicknesses also at hig
...
h temperatures, Measurements of properties of materials, including fluids and gases We are delivering a standard version of the software (for any Microsoft Windows up to 10 x64 with Microsoft Hardware certification report Approved) and for special needs: SDK with ready to use examples for LabView, MATLAB x64, C++ wrapper for dll, Python and Linux., and also low-level description of how to control our devices directly from any USB tools
>

Wireless TOFD scanner

Quick, accurate and highly reproducible welds testing. The System operates wirelessly and is compat
...
ible with any type of Windows based Laptop, Desktop or Tablet.
>

Sci Aps Z-Series Portable Handheld Analysers

The world’s only handheld analyzer that measures carbon content in stainless (yes even L-grades),s
...
teels, and cast irons. Also accepted for low Si analysis for sulfidic corrosion analysis, and is widely used in the power industry for Cr analysis, for flow accelerated corrosion applications.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window