where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -
Technical Discussions
India, Joined Jul 2019, 6


Joined Jul 2019
04:57 Aug-17-2019
UT Structural job


What is the procedure for Rectangular Hollow Section structural job. Job thickness 12.5 and 16mm. Butt joint and full penetration.


seyed meeran
NDT Inspector,
heavy engineering and shipbuilding kuwait, India, Joined Feb 2017, 23

seyed meeran

NDT Inspector,
heavy engineering and shipbuilding kuwait,
Joined Feb 2017
09:07 Aug-17-2019
Re: UT Structural job
In Reply to Rahul at 04:57 Aug-17-2019 (Opening).

hi dear u have to use the technique according to the application of the job whether the job is used in structural application u can used aws D 1.1 .. if u use the aws d1.1 we use only iiw v1 block with 1.5 dia reflector that is basic calibration block .. according to the application whether it is statically loaded or cyclically loaded u can follow the acceptance level also . if it is used in offshore u can apply api rp 2x...


Product Spotlight


Next generation for Phased Array UT is here now with FMC/TFM! Have higher resolution imaging, impr
oved signal to noise ratio, characterize, size and analyze defects better with access to several wave mode views and save raw FMC data for higher quality analysis.  Some of the benefits are:
  • Beautiful Image! Easier to understand what you're looking at
  • Completely focused in entire image or volume
  • Much easier to define setups before inspection
  • Easier to decipher geometry echoes from real defects
  • Oriented defects (e.g. cracks) are imaged better
  • See image from different wave modes from one FMC inspection
  • FMC data can be reprocessed/analyzed without going back to the field

Varex Imaging Large Field of View (FOV) Digital Detector Arrays (DDAs)

A larger FOV DDA can reduce the space and volume of the X-ray inspection system on the factory floor
, enable faster scanning times, better throughput and better resolution images at a lower dose. Customers can also save time and money. With these benefits in mind, Varex Imaging has designed a family of large FOV detectors (4343HE, XRD 1611, 4343DX-I, 4343CT) for our industrial imaging customers.

Sci Aps Z-Series Portable Handheld Analysers

The world’s only handheld analyzer that measures carbon content in stainless (yes even L-grades),s
teels, and cast irons. Also accepted for low Si analysis for sulfidic corrosion analysis, and is widely used in the power industry for Cr analysis, for flow accelerated corrosion applications.

GUL QSR1® Scanning

How do you measure pipe wall thickness without direct access to the area? QSR® Scanning - Guide Wav
e Quantitative Short Range Scanning.

We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
this is debug window