where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -

IMechE Engineering Training Solutions
World leading provider of Non-Destructive Testing and Corrosion Prevention and Coatings training, examinations and Level 3 Consultancy Services

319 views
Technical Discussions
Faran
Engineering
FFC Pakistan, Pakistan, Joined May 2005, 17

Faran

Engineering
FFC Pakistan,
Pakistan,
Joined May 2005
17
08:26 May-12-2005
ECT Equipment: Purchase and Questions

we need to purchase a eddy current testing equipment & also devolop its skill. any one who has recently gone through this phase pls share his experince regarding choice of the equipment, what are basic parameters that should be addressed & known by us, in order to adopt this technique for effectively monitoring corrosion in tubes of heat exchangers , material of tubes being, Carbon steel, low alloy steel, Stainless Steel, Titanium.

We need to inspect the thickness of the Zr lining having a nominal thickness of 0.7 mm, in a 25-22-2 Ni-Cr-Mo tube of thickness 2mm.

1. which Eddy current equipment is best for thi? Qutations are also invited along with brochures.

2. If someone has alreaady performed it were the results satisfactory, what type of probe & frequencies are useful?

3. Is it neccesary to use multiple frequencies to get better & reliable results. Does the use of multiple frequencies more complex in analysis?

4. How much reliable is Eddy current testing in inspection of exchanger tubes of following material
O.D Wall thk Tube Matrl
27mm 3.5mm SB 338 Gr.3 (Titanium)
¾ inch 2.11 mm 25-22-2 Cr-Ni-Mo (SS)
2 inch 2.11 mm A213 TP 316L (SS)
19mm 2.11mm A209 T1 (low alloy Steel)

is the technique eqaully good for carbon steel

Pls reply me at faranffc@yahoo.com


    
 
 

Product Spotlight

Sci Aps Z-Series Portable Handheld Analysers

The world’s only handheld analyzer that measures carbon content in stainless (yes even L-grades),s
...
teels, and cast irons. Also accepted for low Si analysis for sulfidic corrosion analysis, and is widely used in the power industry for Cr analysis, for flow accelerated corrosion applications.
>

Teletest Focus+

Teletest Focus+ electronics have superior capabilities than rivals on the market. Beyond the usual
...
test features, Focus+ has 24 transmit channels and 24 receive channels, with an additional on-board switching capabilities. The instrument's frequency range is 10–300 kHz.
>

YXLON FF35 CT

High Resolution Industrial CT System for Small/Medium-Sized Parts Inspection The YXLON FF35 CT
...
computed tomography system is designed to achieve extremely precise inspection results for a wide range of applications. Available in a single or dual tube configuration, it is perfect for very small to medium-sized parts inspection in the automotive, electronics, aviation, and material science industries.
>

XRHRobotStar

In high volume industries like automotive the requirement for a hundred percent X-ray inspection c
...
reates a bottleneck in the production. The XRHRobotStar is a fully Automated Defect Recognition (ADR) capable robot-system that allows an ultra-fast in-line inspection.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window