where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -
552 views
Technical Discussions
daniel iordache
daniel iordache
06:37 May-05-2004
oil storage tank -evaluation

hello.
does anyone know how to evaluate laminations that where found in first course of 30000 bls oil storage tank .

subject oil storage tank -30000 bls

first course content 12 plates-

for each one at ut survey have been found 7-20 areas affected by lamination wide fro 20 x20mm to 800 x 500mm at depthes from 5 to 10 mm - nominal thickness is 14-15mm.

is rejected or accepted
-i will send the original report

thanks daniel



    
 
 Reply 
 
Luis Alca
Luis Alca
03:15 Jun-06-2005
Re: oil storage tank -evaluation
Hello:
I'm working in a thermoelectrical plant and we are involved in the maintenance of the oil storage tanks, your question is very interesting for me because that problem is not very know here, however our plant has 40 years old and I think maybe we have those problems.
I think is very late to answer your question but we would be very happy if you can send us the report.
Thanks Luis!!

----------- Start Original Message -----------
: hello.
: does anyone know how to evaluate laminations that where found in first course of 30000 bls oil storage tank .
: subject oil storage tank -30000 bls
: first course content 12 plates-
: for each one at ut survey have been found 7-20 areas affected by lamination wide fro 20 x20mm to 800 x 500mm at depthes from 5 to 10 mm - nominal thickness is 14-15mm.
: is rejected or accepted
: -i will send the original report
: thanks daniel
------------ End Original Message ------------




    
 
 Reply 
 
abuzeid
abuzeid
02:00 Aug-24-2006
Re: oil storage tank -evaluation
----------- Start Original Message -----------
: hello.
: I need to send me acopy of the methods of oil storage tank maintenance
thanks


    
 
 Reply 
 

Product Spotlight

UCI Hardness Tester NOVOTEST T-U2

UCI hardness tester NOVOTEST T-U2 is is used for non-destructive hardness testing of: metals and
...
alloys by scales of hardness: Rockwell (HRC), Brinell (HB), Vickers (HV); non-ferrous metals, alloys of iron etc., and using five additional scales for calibration; with tensile strength (Rm) scale determines the tensile strength of carbon steel pearlitic products by automatic recalculation from Brinell (HB) hardness scale.
>

Conformable wedge transducer

The conformability is obtained with a flexible membrane filled with water between the transducer and
...
the inspected component. The coupling between the membrane and the component requires a small quantity of water or couplant. The conformable wedge combines the acoustic performance of immersion technique with good coupling and low attenuation.
>

NEW Wheel Type Phased Array Probe

DOPPLER NEW Wheel Type Phased Array Probe, more stable, new tyre makes lesser acoustic attenuation
...
, much lighter makes easier to handle, more slim size, magnetic and mechanical encoder optional etc...more
>

GUL QSR1® Scanning

How do you measure pipe wall thickness without direct access to the area? QSR® Scanning - Guide Wav
...
e Quantitative Short Range Scanning.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window