where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -
527 views
Technical Discussions
dharmaraj
dharmaraj
03:52 Jul-06-2005
film viewers.

Hai friends,
How to calibrate the film viewer.


 
 Reply 
 
Ed T.
Ed T.
06:11 Jul-09-2005
Re: film viewers.
----------- Start Original Message -----------
: Hai friends,
: How to calibrate the film viewer.
------------ End Original Message ------------

Try using a density strip.


 
 Reply 
 
N.Arunachalam
N.Arunachalam
07:40 Jul-29-2005
Re: film viewers.
----------- Start Original Message -----------
: : Hai friends,
: : How to calibrate the film viewer.
: Try using a density strip.
------------ End Original Message ------------

We have to use the light meter to measure the quantity of light from the viewer, if the viewer is meant for measuring film density of 4 , find the incident light requirement using the Code requiremnt at the surface of the viewer,

Assume 30 lux of transmited light on 4 density film is required for better viewing by normal eye condition then using the log priciple ,30 X 10,000 lux of incident light is required on the surface of viewer, but you cannot measure this high quantity light by normal low range light meters( in the market available meters having maximum 3000 lux only), so measure the light intensity in a pre determine vertical ( 750mm) distance from the viewer middle surface and calculate the amount of light intensity on the viewer by using inverse square law priciple.the calculated light must be more than 300,000 lux on the surface,( this value may vary if you asume differnt value of transmitted light indensity)



 
 Reply 
 

Product Spotlight

CIVA 2017 UT Module

CIVA NDE Simulation Software is the world leader of NDT Simulation. The UT simulation Module incl
...
udes: - "Beam computation": Beam propagation simulation - "Inspection Simulation": Beam interaction with flaws or specimens The user can simulate a whole inspection process (pulse echo, tandem or TOFD) with a wide range of probes (conventional, Phased- arrays or EMAT), components, and flaws.
>

TESTD-PT SYSTEM

Pulse thermography is a non-contact test method that is ideal for the characterization of thin fil
...
ms and coatings or the detection of defects. With a remarquable short test time and a high detection sensitivity, the Telops TESTD-PT is the perfect tool for non- destructive testing. With such high frame rates, it is even possible to investigate highly conductive or diffusive materials.
>

IRIS 9000Plus - Introducing the next generation of heat exchanger inspection.

Representing the seventh generation of the IRIS system, the IRIS 9000 Plus has nearly 200 years of c
...
ombined field inspection experience incorporated in its design. This experience combined with a strong commitment to quality and a history of innovation has made Iris Inspection Services® the undisputed leader in IRIS technology.
>

SONOAIR - air-coupled Phased Array Ultrasonic Inspection System

For highly attenuating materials, the performance of the system is critical. The ultrasonic sensors,
...
the scanning area and the system settings should be flexibly adapted to the test task and the material. These high expectations are met with the new and modular testing system SONOAIR. With the world’s first air-coupled phased-array UT inspection system SONOAIR we developed a technology that works with up to 4 transmitter and receiver channels with freely configurable square wave burst transmitters as wells as low noise receiving amplifiers.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window