where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -

430 views
Technical Discussions
John James
Self Employed, Australia, Joined Jun 2005, 3

John James

Self Employed,
Australia,
Joined Jun 2005
3
03:04 Dec-10-2005
Iris

I have heard that Shell in Houston(USA)offers Iris qualifications. Can any tell me anymore.

Regards
John


 
 Reply 
 
F.Buijsen
F.Buijsen
02:55 Dec-13-2005
Re: Iris
----------- Start Original Message -----------
: I have heard that Shell in Houston(USA)offers Iris qualifications. Can any tell me anymore.
: Regards
: John
------------ End Original Message ------------

TiaT europe bv in The Netherlands offers IRIS level 1 training. +31 165 552461


 
 Reply 
 
Jim Yukes
Jim Yukes
06:51 Jan-06-2006
Re: Iris
----------- Start Original Message -----------
: I have heard that Shell in Houston(USA)offers Iris qualifications. Can any tell me anymore.
: Regards
: John
------------ End Original Message ------------

I understand that Shell (USA) only qualifies IRIS technicians if they have an internal request from a Shell plant


 
 Reply 
 

Product Spotlight

A1525 SOLO

A1525 Solo – the most compact and affordable TMF unit with two phased array transducers and 3D v
...
isualization and analysis software in standard delivery set. A compact, ergonomic and easy to handheld Phased Array unit based on Total Focusing Method for easy-going imaging of inspection objects with two-dimensional and three-dimensional visualization and evaluation of inspection results.
>

UCI Hardness Tester NOVOTEST T-U2

UCI hardness tester NOVOTEST T-U2 is is used for non-destructive hardness testing of: metals and
...
alloys by scales of hardness: Rockwell (HRC), Brinell (HB), Vickers (HV); non-ferrous metals, alloys of iron etc., and using five additional scales for calibration; with tensile strength (Rm) scale determines the tensile strength of carbon steel pearlitic products by automatic recalculation from Brinell (HB) hardness scale.
>

Robotic laser shearography enables 100% inspection of complex, flight-critical composite structures

An article in “Composites World Magazine” showcases Non Destructive Testing of aero-structures
...
with Laser Shearography. Over the years Dantec Dynamics has supplied many solutions for the aerospace industry. Referring to specific customer projects several of these cases are examined to outline the advantages of using Laser Shearography for automated defect detection.
>

Extended Range Variable Wall® Piping Calibration Blocks for Longseam Inspection

This set of two blocks has been specially designed for situations where ultrasonic examination tak
...
es place circumferentially or “around the curve” for applications such as inspection of longseam welds in piping and vessels. Jointly designed by PH Tool and Holloway NDT, the blocks feature side-drilled hole reflectors positioned within novel compound-curves, each with multiple thickness steps. The unique design results in a light and compact form factor, with the largest block weighing just over 15 lbs and spanning just 16 ¾”. Coverage is provided for nominal pipe sizes from 6” to 10” in the small block and 12” to a whopping 56” in the large block. The compound OD curves and multiple wall thicknesses actually exceed ASME requirements, providing exceptional signal response and measurement accuracy. Properly managing beam divergence off the ID and stabilizing beam skew due to probe rocking is essential to maintaining a consistent calibration when inspecting lengthwise on curved surfaces.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window