where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -
637 views
Technical Discussions
Ron Olson
R & D, Aviation
The Best Aviation Company In The World, USA, Joined Feb 2005, 23

Ron Olson

R & D, Aviation
The Best Aviation Company In The World,
USA,
Joined Feb 2005
23
00:02 Sep-23-2006
Tap Hammers

Besides those recommended by the FAA in AC43-13, can someone tell me where I can find some tap hammers?

Is there a vendor that sells tap hammers? For metal bonds? For composites?

I remember using a very dense (steel) one inch head and three inch lever arm with a yellow plastic handle. Who makes this?

Thank you.


 
 Reply 
 
Roberto Falconio
Engineering, NDT/Metrology SUPERVISOR
El Salvador, Joined Feb 2000, 13

Roberto Falconio

Engineering, NDT/Metrology SUPERVISOR
El Salvador,
Joined Feb 2000
13
05:36 Sep-24-2006
Re: Tap Hammers
Hi Ron,

Basically you may manufacture it according to aircraft manufacturer recomendations in case of a hand held mechanical tapping, however if you eould like an electronic equipment you may look for the woodpecker manufacturer by mitsui in Japan

Best Regards
RF

----------- Start Original Message -----------
: Besides those recommended by the FAA in AC43-13, can someone tell me where I can find some tap hammers?
: Is there a vendor that sells tap hammers? For metal bonds? For composites?
: I remember using a very dense (steel) one inch head and three inch lever arm with a yellow plastic handle. Who makes this?
: Thank you.
------------ End Original Message ------------




 
 Reply 
 

Product Spotlight

OmniScan™ X3 flaw detector

The OmniScan X3 flaw detector is a complete phased array toolbox. Powerful tools, like total focus
...
ing method (TFM) images and advanced visualization capabilities, enable you to complete your inspection with greater confidence.
>

TraiNDE UT

TraiNDE UT is a virtual tool associated with a signal database which simulates real inspection con
...
ditions for numerous applications (Type A/V1 block, DAC block, welds and plates).
>

Conformable wedge transducer

The conformability is obtained with a flexible membrane filled with water between the transducer and
...
the inspected component. The coupling between the membrane and the component requires a small quantity of water or couplant. The conformable wedge combines the acoustic performance of immersion technique with good coupling and low attenuation.
>

Aerospace Systems - Automated Ultrasonic Inspection

USL are specialists in the design and manufacture of turnkey ultrasonic inspection systems for aer
...
ospace applications. From monolithic composites to complex honeycomb structures. This video shows just a few examples of what is possible, find out more at: www.ultrasonic-sciences.co.uk
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window