where expertise comes together - since 1996

Web's Largest Portal of Nondestructive Testing (NDT)
Open Access Database (Conference Proceedings, Articles, News), Exhibition, Forum, Network

All Forum Boards
Technical Discussions >
weld inspection
Career Discussions
Job Offers
Job Seeks
Classified Ads
About NDT.net
Articles & News

STARMANS elctronics, s. r.o.
STARMANS is the Central European leading producer of industrial measuring, detecting and combined equipments for non-destructive testing

895 views
02:53 Dec-12-2006

hcumbaa

NDT Inspector,
USA,
Joined Aug 2007
10
weld inspection

1 plate is .600" the other is .750" thick angle beam inspection do you ut for both thicknesess when shooting from the thinner side or the thinner member twice? if you can associate a technique it would be appreciated Thanks


 
05:01 Dec-13-2006

Roberto Falconio

Engineering, NDT/Metrology SUPERVISOR
El Salvador,
Joined Feb 2000
13
Re: weld inspection Hi Cumbaa,

could you please specify the type of joint and bevel?
regards
RF

----------- Start Original Message -----------
: 1 plate is .600" the other is .750" thick angle beam inspection do you ut for both thicknesess when shooting from the thinner side or the thinner member twice? if you can associate a technique it would be appreciated Thanks
------------ End Original Message ------------




 
03:12 Dec-19-2006

Herbert Cumbaa

NDT Inspector,
USA,
Joined Aug 2007
10
Re: weld inspection
it's a V-bevel full penetration, no backing, structural use.




 


© NDT.net - The Web's Largest Portal of Nondestructive Testing (NDT) ISSN 1435-4934

Open Access Database, |Conference Proceedings| |Articles| |News| |Exhibition| |Forum| |Professional Network|