where expertise comes together - since 1996

Web's Largest Portal of Nondestructive Testing (NDT)
Open Access Database (Conference Proceedings, Articles, News), Exhibition, Forum, Network

All Forum Boards
Technical Discussions >
EN 10160
Career Discussions
Job Offers
Job Seeks
Classified Ads
About NDT.net
Articles & News

Mammon Technologies LLP
1-Stop Shop for all your NDT Needs. Radiography, GPR, Thermography and acoustic devices. We sell worldwide. We train worldwide. We support worldwide.

193 views
00:12 Jul-25-2008
yasin karavacýoglu
EN 10160

Dear Expert;
We work on UT test for plate.
For EN 10160 class S1;
standard say permisible defect size and number of defects are following :

Area
Defect mm² Max. number of defects
Within 1 m²
100 - 1000 15

My question is if there is 15 defects in this range and also there is some defect that's sizes is lower than 100mm². At this condition this plate is acceptable or not ?

Thank you




 


© NDT.net - The Web's Largest Portal of Nondestructive Testing (NDT) ISSN 1435-4934

Open Access Database, |Conference Proceedings| |Articles| |News| |Exhibition| |Forum| |Professional Network|