where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -
638 views
Technical Discussions
gowrishankarwuriti
R & D, scientist
ISRO, India, Joined Nov 2008, 34

gowrishankarwuriti

R & D, scientist
ISRO,
India,
Joined Nov 2008
34
05:14 Nov-11-2008
X-RAY

sir,
How X-Ray exposure parameters can be freezed if two dissimilar materials (say Copper and Inconel )joined together with ebw other than trial and error basis ?


 
 Reply 
 
S.V.Swamy
Engineering, - Material Testing Inspection & Quality Control
Retired from Nuclear Fuel Complex , India, Joined Feb 2001, 787

S.V.Swamy

Engineering, - Material Testing Inspection & Quality Control
Retired from Nuclear Fuel Complex ,
India,
Joined Feb 2001
787
07:21 Nov-11-2008
Re: X-RAY
Theoretically, you can calculate the equivalent thickness of each (in terms of steel) and then set the parameters for that thickness of steel. With a method called bracketing (a little higher and a little under exposure around the theoretical value), you should hit the correct exposure parameter in just a couple of trials.

Swamy
NDT Guru

----------- Start Original Message -----------
: sir,
: How X-Ray exposure parameters can be freezed if two dissimilar materials (say Copper and Inconel )joined together with ebw other than trial and error basis ?
------------ End Original Message ------------




 
 Reply 
 

Product Spotlight

Research and Applications Development For NDT

The Research and Applications Development (RAD) group is a newly formed team within Acuren dedicat
...
ed to tackling challenging inspection problems. Our focus is the development of novel, field deployable, advanced inspection techniques for use in cases where standard NDT methods are ineffective. We don't wait for new innovations, we engineer them. From concept to commissioning.
>

Combination of Digital Image Correlation and Thermographic Measurements

The combination of measuring results from the digital image correlation (ARAMIS, DIC) and temperat
...
ure measuring data from infrared cameras permits the simultaneous analysis of the thermal and mechanical behavior of test specimens in the materials and components testing field.
>

OmniScan™ X3 flaw detector

The OmniScan X3 flaw detector is a complete phased array toolbox. Powerful tools, like total focus
...
ing method (TFM) images and advanced visualization capabilities, enable you to complete your inspection with greater confidence.
>

Conformable wedge transducer

The conformability is obtained with a flexible membrane filled with water between the transducer and
...
the inspected component. The coupling between the membrane and the component requires a small quantity of water or couplant. The conformable wedge combines the acoustic performance of immersion technique with good coupling and low attenuation.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window