- since 1996 -
Next generation for Phased Array UT is here now with FMC/TFM! Have higher resolution imaging, impr
oved signal to noise ratio, characterize, size and analyze defects better with access to several wave mode views and save raw FMC data for higher quality analysis. Some of the benefits are:
Echomac® PA Bar Tester
The Echomac® PA BT provides 100% inspection of round bars for core and surface defects, at speeds u
p to 2 m/sec, depending on the specific application. The unit allows producers to handle a much larger range of diameters in one installation, and is available in 3 models to test 10 – 75mm diameter (small model); 20 – 130mm (medium model) or 50 – 254mm (large model) bars.
Ultrasonic Squirter/Gantry System
TecScan’s NDT Ultrasonic Gantry Systems are industrial Squirter scanners designed for non-destru
ctive quality testing and raster scanning of large structures and parts. The Gantry Systems are usually composed of an Industrial Mechanical Scanner and a Control Room with System Workstation.
UCI Hardness Tester NOVOTEST T-U2
UCI hardness tester NOVOTEST T-U2 is is used for non-destructive hardness testing of: metals and
alloys by scales of hardness: Rockwell (HRC), Brinell (HB), Vickers (HV); non-ferrous metals, alloys of iron etc., and using five additional scales for calibration; with tensile strength (Rm) scale determines the tensile strength of carbon steel pearlitic products by automatic recalculation from Brinell (HB) hardness scale.