where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -

199 views
Job Offers
J. Hill
Director, Field Operations
IMAC, USA, Joined Jun 2008, 4

J. Hill

Director, Field Operations
IMAC,
USA,
Joined Jun 2008
4
07:05 Jun-17-2008
NDT Level II or III MT

Job Location: MI, USA
offered by  

THIS POSITION IS OPEN TO U.S. CITIZENS ONLY DUE TO THE CONTRACTORS ASSOCIATION WITH THE DEPARTMENT OF DEFENSE. I have an opening for a temporary position: NDT Level II or III MT Specialist. The job is slated to start at the beginning of July, 2008. The position would require crossing a picket line during a labor dispute. The job details are as follows:
Position Summary: The NDT Level II or III Specialist reports to the Quality Leader and is responsible for the day-to-day technical support for all nondestructive testing. This individual will apply the NDT technologies of Magnetic Particle Inspection (MT). This individual will work in concert with the Quality Leader to provide the overall technical leadership and future development direction for Nondestructive Evaluation at our client's facility.
· Will make final determination on acceptability of questionable hardware found by the NDT process, maintain all necessary documentation of the controls of the NDT processes, including their solutions and equipment.
· Will develop, update and institute NDT procedures and work instructions as required for existing equipment and implement new NDT inspection equipment, including necessary capability studies, procedures, work instructions and inspector training.
Position Requirements: The position requires a NDT level II or III MT certification.
Compensation: Hourly rate of $25.00, (negotiable). Perdiem $35.00 a day. Housing provided. Will be working 7 days a week 12 hours per day. Reply by email for consideration.


    
 
 

Product Spotlight

NEW Wheel Type Phased Array Probe

DOPPLER NEW Wheel Type Phased Array Probe, more stable, new tyre makes lesser acoustic attenuation
...
, much lighter makes easier to handle, more slim size, magnetic and mechanical encoder optional etc...more
>

FMC/TFM

Next generation for Phased Array UT is here now with FMC/TFM! Have higher resolution imaging, impr
...
oved signal to noise ratio, characterize, size and analyze defects better with access to several wave mode views and save raw FMC data for higher quality analysis.  Some of the benefits are:
  • Beautiful Image! Easier to understand what you're looking at
  • Completely focused in entire image or volume
  • Much easier to define setups before inspection
  • Easier to decipher geometry echoes from real defects
  • Oriented defects (e.g. cracks) are imaged better
  • See image from different wave modes from one FMC inspection
  • FMC data can be reprocessed/analyzed without going back to the field
>

Compact NDT inspection-heads for measurements with active thermography

The compact inspection head is suitable for thermographic ndt tasks. The uncooled infrared camera
...
is specially developed for NDI-tasks and offers a thermal sensitivity until now known only from thermal imagers with cooled detector. All required components and functions are integrated into the inspection-head. You will only need an ethernet cable to connect the sensor with the evaluation system.
>

TVC awarded UKAS accreditation

TVC are delighted to finally announce we have been awarded UKAS accreditation for our calibration
...
laboratory. Laboratory accreditation to ISO/IEC 17025:2005 enables us to conduct the Electrical Verification of Ultrasonic Flaw Detection Equipment to BS EN 12668-1:2010. It has taken many months of hard work and we want to thank our staff for all their efforts during this massive undertaking.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window
s