where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -

170 views
Job Offers
Brett Todd
Brett Todd
07:12 Jun-24-2008
NDT Inspector L2 MPI

Job Location: Abu Dhabi UAE
offered by  

Seeking to employ level 2 MPI with hands on experience within last 12 months , must be able to prove experience. Candidate will be trained to PCN Level 2 MPI.


    
 
 

Product Spotlight

SONOAIR - air-coupled Phased Array Ultrasonic Inspection System

For highly attenuating materials, the performance of the system is critical. The ultrasonic sensors,
...
the scanning area and the system settings should be flexibly adapted to the test task and the material. These high expectations are met with the new and modular testing system SONOAIR. With the world’s first air-coupled phased-array UT inspection system SONOAIR we developed a technology that works with up to 4 transmitter and receiver channels with freely configurable square wave burst transmitters as wells as low noise receiving amplifiers.
>

TVC awarded UKAS accreditation

TVC are delighted to finally announce we have been awarded UKAS accreditation for our calibration
...
laboratory. Laboratory accreditation to ISO/IEC 17025:2005 enables us to conduct the Electrical Verification of Ultrasonic Flaw Detection Equipment to BS EN 12668-1:2010. It has taken many months of hard work and we want to thank our staff for all their efforts during this massive undertaking.
>

FAAST-PA! OEM Patented phased Array for high speed UT inspection

Multiangle, Multifocus, Multifrequency, Multibeam. Instead of stacking UT electronics and having m
...
any PA probes, FAAST-PA is able to transmit all delay laws within ONE single shot in Real time.
>

Digital Radiography for Concrete Inspection

In the construction industry (buildings, bridges) there is a need for fast non- destructive means,
...
most commonly to locate targets (Pipes, Re-bars, Conduit, Fittings etc.) within concrete structures prior to drilling, cutting or coring. Measuring reinforcements is also performed for static calculations and to detect corrosion problems and damages. Cracks and voids can also be visualized. The examinations are not only restricted to concrete constructions; they can also be applied to reinforced masonry made of natural stones or bricks.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window