The Largest Open Access Portal of Nondestructive Testing (NDT)

DASEL SISTEMAS Our Phased Array equipments, based on SITAU Technology, are among the PAS highest performance in the market. 231 views Job Seeks venugopal venugopal 04:08 Sep-18-2008 ToFD Inspector Job Location: India PCN EN473 ToFD Level II, PCN EN473 UT 3.1, 3.2 & Critical Sizing Level II. Four years experience as ToFD Inspector, wish to travel across the world. Resume on Request.   Translate  Close

Product Spotlight Immersion systems StandScanMaster Systems (IRT) Ltd. ScanMaster ultrasonic immersion systems are designed for high throughput, multi shift operation in a ... n industrial or lab environment. These fully integrated systems provide various scanning configurations and incorporate conventional and phased arrays technologies to support diverse applications, such as inspection of disks, bars, shafts, billets and plates. All of ScanMaster immersion systems are built from high accuracy scanning frames allowing for scanning of complex parts and include a multi-channel ultrasonic instrument with exceptional performance. The systems are approved by all major manufacturers for C-scan inspection of jet engine forged discs. Together with a comprehensive set of software modules these flexible series of systems provide the customer with the best price performance solutions. > 5 Showcases5 Videos ISAFE3 Intrinsically Safe Sensor System StandVallen-Systeme GmbH ISAFE3 intrinsically safe sensor system of Vallen Systeme is especially targeted at the petrochemica ... l - as well as oil and gas transportation industry. The sensor system is designed for permanent monitoring or periodic inspection tasks. Sensors are available for different AE-frequency ranges optimized for corrosion and fatigue crack detection and other applications. The ISAFE 3 sensor system consists of an AE-sensor (model ISAS3) certified according to ATEX/IEC for installation in zone 0, gas group IIC, IP68, 20 to +60 °C, and a signal isolator (model SISO3) certified for installation in zone 2. An ISAS3 sensor can be mounted in atmosphere or submerged, e.g. in water or crude oil. It is supported by mounting tools for temporary (magnets) or permanent (welded) installation. ISAFE3 supports automatic sensor coupling test and can be used with any AE signal processor supporting 28V supply at 90 mA peak, e.g. Vallen Systeme ASIP-2/A. > 2 Showcases Echomac® PA Bar Tester StandMagnetic Analysis Corporation The Echomac® PA BT provides 100% inspection of round bars for core and surface defects, at speeds u ... p to 2 m/sec, depending on the specific application. The unit allows producers to handle a much larger range of diameters in one installation, and is available in 3 models to test 10 – 75mm diameter (small model); 20 – 130mm (medium model) or 50 – 254mm (large model) bars. > 5 Showcases5 Videos Cygnus 6+ PRO Multi-Mode Ultrasonic Thickness Gauge StandCygnus Instruments Ltd The Cygnus 6+ PRO thickness gauge is the most advance gauge within the Cygnus range with key featu ... res including: comprehensive data logging; A-scan and B-scan display; manual gain control; Bluetooth connectivity; and much more. With its unique dual display and three measuring modes (Multiple-Echo, Echo-Echo and Single-Echo), this surface thickness gauge offers maximum versatility for inspections. > 5 Showcases5 Videos more Showcases

Share...

• Home
• Exhibition
• Archive
• Forum
• Jobs
• Members
• Events
• Directory
• NDT A-Z

• Advertise
• Privacy Policy
• Contact & Imprint
• About

© NDT.net - Where expertise comes together. The Largest Open Access Portal of Nondestructive Testing (NDT)- since 1996