- since 1996 -
Next generation for Phased Array UT is here now with FMC/TFM! Have higher resolution imaging, impr
oved signal to noise ratio, characterize, size and analyze defects better with access to several wave mode views and save raw FMC data for higher quality analysis. Some of the benefits are:
NDT Master Lecturer
In the program both university professors and practitioners will give lectures, which guarantees the
oretical depth and practical inside. Academic Director: Prof. Dr. Christian Boller
The following lecturers are not complete: Prof. Tadeusz Stepinski, Prof. Wieslaw Staszewski, Prof. Frank Walther, Prof. Giovanni Bruno, Prof. Gerd Dobmann, Prof. Philippe Guy
HARDNESS TESTER TKM-459CE combi
TKM-459CE combi applies 2 methods of hardness control: UCI and Leeb. It provides high-accuracy tes
ting of metals and alloys as well as items of different sizes and configurations, their hardened layers and galvanic coatings. Device represents results in HB, HRC, HV and others. Shock-, dust- and water-proof housing with intuitive software make this gauge easy to use in all working conditions.
Eddy Current inspection : RotoETscan Rotating Head
The rotating head RotoETscan detects the presence of longitudinal surface or sub surface defects a
t high speed. The rotating head is often installed directly on the production line. It is generally dedicated to the control of long products such as tubes, bars and wires, made of ferrous or non-ferrous material. It can also be used for inspection of small parts (billets).