The Largest Open Access Portal of Nondestructive Testing (NDT)

	310 views Classified Ads John Tumber NDT Inspector, - USA, Joined May 2008, 1 John Tumber NDT Inspector, - USA, Joined May 2008 1 02:12 May-22-2008 Needed matec and sonix Hello we are in need of Matec model SR-9000 pulser recievers and Sonix str*864 digitizers. these are for and emmbedded system built around these older products. any leads would be great thanx john   Translate  Close

Product Spotlight Conformable wedge transducer StandIMASONIC SAS The conformability is obtained with a flexible membrane filled with water between the transducer and ... the inspected component. The coupling between the membrane and the component requires a small quantity of water or couplant. The conformable wedge combines the acoustic performance of immersion technique with good coupling and low attenuation. > Research and Applications Development For NDT StandECLIPSE SCIENTIFIC The Research and Applications Development (RAD) group is a newly formed team within Acuren dedicat ... ed to tackling challenging inspection problems. Our focus is the development of novel, field deployable, advanced inspection techniques for use in cases where standard NDT methods are ineffective. We don't wait for new innovations, we engineer them. From concept to commissioning. > 3 Showcases5 Videos OmniScan™ X3 flaw detector StandOlympus Scientific Solutions Americas The OmniScan X3 flaw detector is a complete phased array toolbox. Powerful tools, like total focus ... ing method (TFM) images and advanced visualization capabilities, enable you to complete your inspection with greater confidence. > 37 Showcases13 Videos ISAFE3 Intrinsically Safe Sensor System StandVallen-Systeme GmbH ISAFE3 intrinsically safe sensor system of Vallen Systeme is especially targeted at the petrochemica ... l - as well as oil and gas transportation industry. The sensor system is designed for permanent monitoring or periodic inspection tasks. Sensors are available for different AE-frequency ranges optimized for corrosion and fatigue crack detection and other applications. The ISAFE 3 sensor system consists of an AE-sensor (model ISAS3) certified according to ATEX/IEC for installation in zone 0, gas group IIC, IP68, 20 to +60 °C, and a signal isolator (model SISO3) certified for installation in zone 2. An ISAS3 sensor can be mounted in atmosphere or submerged, e.g. in water or crude oil. It is supported by mounting tools for temporary (magnets) or permanent (welded) installation. ISAFE3 supports automatic sensor coupling test and can be used with any AE signal processor supporting 28V supply at 90 mA peak, e.g. Vallen Systeme ASIP-2/A. > 2 Showcases more Showcases

Share...

• Home
• Exhibition
• Archive
• Forum
• Jobs
• Members
• Events
• Directory
• NDT A-Z

• Advertise
• Privacy Policy
• Contact & Imprint
• About

© NDT.net - Where expertise comes together. The Largest Open Access Portal of Nondestructive Testing (NDT)- since 1996