- since 1996 -
ISAFE3 Intrinsically Safe Sensor System
ISAFE3 intrinsically safe sensor system of Vallen Systeme is especially targeted at the petrochemica
l - as well as oil and gas transportation industry. The sensor system is designed for permanent monitoring or periodic inspection tasks. Sensors are available for different AE-frequency ranges optimized for corrosion and fatigue crack detection and other applications. The ISAFE 3 sensor system consists of an AE-sensor (model ISAS3) certified according to ATEX/IEC for installation in zone 0, gas group IIC, IP68, 20 to +60 °C, and a signal isolator (model SISO3) certified for installation in zone 2. An ISAS3 sensor can be mounted in atmosphere or submerged, e.g. in water or crude oil. It is supported by mounting tools for temporary (magnets) or permanent (welded) installation. ISAFE3 supports automatic sensor coupling test and can be used with any AE signal processor supporting 28V supply at 90 mA peak, e.g. Vallen Systeme ASIP-2/A.
High-performance Linear Phased Array Probes
Available to order from stock in a range of 5MHz – 7.5MHz and from 16 to 64 elements. Designed w
ith piezo-composite elements, Phoenix phased array probes provide high-resolution imaging to maximise sensitivity; accurate ultrasonic detection and sizing of defects in welds; and effective corrosion mapping. Housed in a rugged stainless steel case for on-site industrial NDT applications.
PROlineTOP Plug & Play Ultrasonic inspection device
As Plug & Play solution it units all control and operation elements in a small housing and therefo
re replaces the typical control cabinet...
NDT.net launches mobile-friendly design
NDT.net has revamped its website providing a mobile-friendly design.The front page received a comp
letely new design and all other sections are now reacting responsively on mobile devices. This has been a major step to make our website more user- friendly.