Mobile-Friendly Implementation in Progress | |   |
 148 views |
 Job Seeks | | vemkat
 | vemkat
|  06:48 Jul-14-2009
NDT Level III ,Welding ,Painting Inspector looking for Job
Job Location: World wide ASNT Level 3 VT,RT,UT,MT,&PT Certified Welding,Painting Inspector looking for Short term Job
Thanks | |
| | | |
|  | FMC/TFM
Next generation for Phased Array UT is here now with FMC/TFM! Have higher
resolution imaging, improved signal to noise ratio, characterize, size and analyze
defects better with access to several wave mode views and save raw FMC data for
higher quality analysis. Some of the benefits are:
- Beautiful Image! Easier to understand what you're looking at
- Completely focused in entire image or volume
- Much easier to define setups before inspection
- Easier to decipher geometry echoes from real defects
- Oriented defects (e.g. cracks) are imaged better
- See image from different wave modes from one FMC inspection
- FMC data can be reprocessed/analyzed without going back to the field
[more]
 Advanced OEM Solutions
3 Showcases |
|  | X-ray CT aids research into defect formation in AM parts
X-ray CT is used to research how additive manufacturing process
parameters influence defect
Nikon Metrology
6 Showcases 3 Videos |
|  |  IntraPhase Athena Phased Array System
The Athena Phased Array system, manufactured by WesDyne NDE Products & Technology, consists of a phased array acquisition system and PC running IntraSpect software. A PC is used to perform acquisition, analysis and storage of the data. System hardware is capable of operating up to four data sets with any combination of phased array or conventional UT probes. NOW AVAILABLE IN 64-64 CONFIGURATION. [more]
AMDATA Products (WesDyne)
9 Showcases |
|  | Digital Radiography for Concrete Inspection
In the construction industry (buildings, bridges) there is a need for fast non-
destructive means, most commonly to locate targets (Pipes, Re-bars, Conduit,
Fittings etc.) within concrete structures prior to drilling, cutting or coring.
Measuring reinforcements is also performed for static calculations and to detect
corrosion problems and damages. Cracks and voids can also be visualized. The
examinations are not only restricted to concrete constructions; they can also be
applied to reinforced masonry made of natural stones or bricks. [more]
Mammon Technologies LLP
4 Showcases |
| More Showcases  |
|
|
|
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
|
|
