where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -

452 views
Technical Discussions
Linas Svilainis
R & D,
Kaunas University of Technology, Lithuania, Joined Nov 1998, 67

Linas Svilainis

R & D,
Kaunas University of Technology,
Lithuania,
Joined Nov 1998
67
08:20 May-14-2002
Moisture % in wood chips

Dear Coleagues,

I need your advice on Moisture % in wood chips measurement.
Best case would be the ready device, but any ideas would be great too.
The moisture has to be measured at dryer income and outlet.
Chips are transported by conveyor belt.
The relative humidity is about 1-3%, we would like to keep it within 1.2-1.8%

Sincerely,

Linas



    
 
 
David Hermanutz
Consultant,
Hbndt.com, China, Joined Jul 2012, 85

David Hermanutz

Consultant,
Hbndt.com,
China,
Joined Jul 2012
85
05:15 May-15-2002
Re: Moisture % in wood chips
: Dear Coleagues,
.
: I need your advice on Moisture % in wood chips measurement.
: Best case would be the ready device, but any ideas would be great too.
: The moisture has to be measured at dryer income and outlet.
: Chips are transported by conveyor belt.
: The relative humidity is about 1-3%, we would like to keep it within 1.2-1.8%
.
: Sincerely,
.
: Linas

Dear Sir,

If you are drying the wood chips and it is your intention to measure the moisture in the drying medium, inlet and outlet, then yes it can be done.

Please contact Panametrics PCI Division.

www.panametrics.com

http://www.panametrics.com/div_pci/pages/products/abhumidity/index.shtml

Best Regards,

David Hermanutz
Panametrics NDT Melbourne



    
 
 

Product Spotlight

NDT Master Lecturer

In the program both university professors and practitioners will give lectures, which guarantees the
...
oretical depth and practical inside. Academic Director: Prof. Dr. Christian Boller
The following lecturers are not complete: Prof. Tadeusz Stepinski, Prof. Wieslaw Staszewski, Prof. Frank Walther, Prof. Giovanni Bruno, Prof. Gerd Dobmann, Prof. Philippe Guy
>

Ultrasonic tomograph for imaging of concrete structures А1040 MIRA

Applicable for concrete inspection allowing imaging of the internal structure of objects from conc
...
rete, reinforced concrete, different stones. The operation applies pulse-echo technique at one-side access to the object. The instrument is feasible for concrete inspection for searching conduct ducts, conduits, detection of foreign inclusions, holes, honeycombing, cracks and other concrete defects.
>

X-ray CT aids research into defect formation in AM parts

X-ray CT is used to research how additive manufacturing process parameters influence defect format
...
ion in AM parts.
>

SONOAIR - air-coupled Phased Array Ultrasonic Inspection System

For highly attenuating materials, the performance of the system is critical. The ultrasonic sensors,
...
the scanning area and the system settings should be flexibly adapted to the test task and the material. These high expectations are met with the new and modular testing system SONOAIR. With the world’s first air-coupled phased-array UT inspection system SONOAIR we developed a technology that works with up to 4 transmitter and receiver channels with freely configurable square wave burst transmitters as wells as low noise receiving amplifiers.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window
s