where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -

YXLON International GmbH
X-ray and CT based NDT systems for a wide range of industrial applications.

334 views
Technical Discussions
David LAVASTRE
Engineering,
EDF CEIDRE, France, Joined Nov 2003, 11

David LAVASTRE

Engineering,
EDF CEIDRE,
France,
Joined Nov 2003
11
00:54 Feb-07-2004
High sensibilty inspection of Ni-base forgings

Hello everybody !
I have a little question about the immersion UT inspection of powder metallurgy forgings (Ni base alloys).
The required sensibility is FBHØ0.2mm at 80%FSH reject with a detection level at FBHØ0.14mm.
- We use calibration block with FBHØ0.4mm in RENE88 or 95.
Actually the settings give :
- FBHØ0.2mm > 80% (that give a FBHØ0.4mm +12dB sensibility)
- FBHØ0.14mm > -6.19dB of 0.2mm (39.2%)
- using a -2dB beam diameter that gives a gate level at 31.13% (-2dB of 39.2%)to assume required detection level.

Can we work with FBHØ0.4mm at 80% FSH ?
With :
- FBHØ0.2mm > 20%
- FBHØ0.4mm > 9.8%
and a gate level of 7.7% with beam diameter -2dB.

What do you think about this second method ?

David





    
 
 

Product Spotlight

FMC/TFM

Next generation for Phased Array UT is here now with FMC/TFM! Have higher resolution imaging, impr
...
oved signal to noise ratio, characterize, size and analyze defects better with access to several wave mode views and save raw FMC data for higher quality analysis.  Some of the benefits are:
  • Beautiful Image! Easier to understand what you're looking at
  • Completely focused in entire image or volume
  • Much easier to define setups before inspection
  • Easier to decipher geometry echoes from real defects
  • Oriented defects (e.g. cracks) are imaged better
  • See image from different wave modes from one FMC inspection
  • FMC data can be reprocessed/analyzed without going back to the field
>

X-ray CT aids research into defect formation in AM parts

X-ray CT is used to research how additive manufacturing process parameters influence defect format
...
ion in AM parts.
>

FAAST-PA! OEM Patented phased Array for high speed UT inspection

Multiangle, Multifocus, Multifrequency, Multibeam. Instead of stacking UT electronics and having m
...
any PA probes, FAAST-PA is able to transmit all delay laws within ONE single shot in Real time.
>

NozzleScan: Radial nozzle scanner with probe skew

NozzleScan is a versatile manual scanning solution developed for the inspection of nozzle welds in
...
both set-through and set-on configurations. Available in both two-axis and three-axis instrument configurations and adaptable to cover a wide range of 90-degree nozzle sizes, from 3" upwards, on ferritic and austenitic materials.The transducer skew axis can also be adjusted, encoded and locked.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window
s