- since 1996 -
ISAFE3 Intrinsically Safe Sensor System
ISAFE3 intrinsically safe sensor system of Vallen Systeme is especially targeted at the petrochemica
l - as well as oil and gas transportation industry. The sensor system is designed for permanent monitoring or periodic inspection tasks. Sensors are available for different AE-frequency ranges optimized for corrosion and fatigue crack detection and other applications. The ISAFE 3 sensor system consists of an AE-sensor (model ISAS3) certified according to ATEX/IEC for installation in zone 0, gas group IIC, IP68, 20 to +60 °C, and a signal isolator (model SISO3) certified for installation in zone 2. An ISAS3 sensor can be mounted in atmosphere or submerged, e.g. in water or crude oil. It is supported by mounting tools for temporary (magnets) or permanent (welded) installation. ISAFE3 supports automatic sensor coupling test and can be used with any AE signal processor supporting 28V supply at 90 mA peak, e.g. Vallen Systeme ASIP-2/A.
New PHAsis module for longitudinal weld seam inspection
PHAsis® Phased Array manual ultrasonic spot weld inspection device is now ideally suited for test
ing of longitudinally welded seams (e.g. Arplas® seam, short line seams) with a length of 3 to 12 mm.
iProbe - USB Phased Array Probe
Turn your PC, Laptop or Tablet into a powerful 32:64 Phased Array system with our USB powered Phas
ed Array iProbe and inspection software package. Perform affordable weld inspection and corrosion mapping inspections with this powerful but small system. The probe has a 100V pulser, 8K PRF, dual axis encoder input and achieves outstanding signal quality.
Combination of Digital Image Correlation and Thermographic Measurements
The combination of measuring results from the digital image correlation (ARAMIS, DIC) and temperat
ure measuring data from infrared cameras permits the simultaneous analysis of the thermal and mechanical behavior of test specimens in the materials and components testing field.