where expertise comes together - since 1996

Web's Largest Portal of Nondestructive Testing (NDT)
Open Access Database (Conference Proceedings, Articles, News), Exhibition, Forum, Network

All Forum Boards
Technical Discussions >
UT of Tee joint
Career Discussions
Job Offers
Job Seeks
Classified Ads
About NDT.net
Articles & News

EXTENDE
EXTENDE, optimize your NDT inspections projects thanks to simulation.

662 views
06:18 Jul-14-2005
Mukesh Kumar Bhatt
UT of Tee joint

Can somebody advice me the technique(Pulse-echo/Phased Array/TOFD) to test full penetration TEE type welded joint with minimum number of scans.


 
07:59 Jul-24-2005

RT. JEYAKUMAR

NDT Inspector
Singapore,
Joined Aug 2002
10
Re: UT of Tee joint Mr.Batt,

Can you give some more details of the weld. Anyway, No of scanning and scanning technique is depends on where you are looking for defects.

If the joint is full pen and if the joint permits both the side access, then you can scan half skip at both the sides so that you may get total coverage.

Please give some more details for more discussions.

With regards,

RT. Jeyakumar


 
06:08 Oct-31-2005

a.a.amiri

Consultant, NDT/QC/WELD INSPECTION
Iran,
Joined Nov 2005
20
Re: UT of Tee joint ----------- Start Original Message -----------
DEAR FRIEND,
BY PULSE ECHO TECHNIQUE,MIN.ONE SCAN BY ANGLE PROBE FROM BEVELED PLATE FOR WELD DEFECT DETECTION,& ONE SCAN BY NORMAL PROBE FROM TOP PLATE(FLANGE) FOR LAMELLAR TEARING IN PLATE OR LACK OF FUSION IN WELD SIDE WALL.


 


© NDT.net - The Web's Largest Portal of Nondestructive Testing (NDT) ISSN 1435-4934

Open Access Database, |Conference Proceedings| |Articles| |News| |Exhibition| |Forum| |Professional Network|