where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -

480 views
Technical Discussions
Azhar Jamil
NDT Engineer
Panama, Joined May 2006, 17

Azhar Jamil

NDT Engineer
Panama,
Joined May 2006
17
07:33 Jun-02-2006
Demagnetization

Can anyone discuss the methods of de-magnetization

What is normal limit of residual magnetism in steam turbine rotors

contact for any queries


 
 Reply 
 
K. Anandam
K. Anandam
05:22 Jun-03-2006
Re: Demagnetization
By and large the residual magnnetic fileld strength of 2 Gauss on the Journal portion and 6 G on the other area of the turbine rotor is acceptable.

This can be done by AC and DC cycles and the same can be carried out by manual or auto mode. Most desirable results are obtained in manual method as per my experience in this field goes.

Auto Demagnetizing equipment which is portable supplied by MPS has been very much useful in this application.

Hope, this information is sufficient.

regards,

--------- Start Original Message -----------
: Can anyone discuss the methods of de-magnetization
: What is normal limit of residual magnetism in steam turbine rotors
:
: contact for any queries
------------ End Original Message ------------




 
 Reply 
 

Product Spotlight

A1525 SOLO

A1525 Solo – the most compact and affordable TMF unit with two phased array transducers and 3D v
...
isualization and analysis software in standard delivery set. A compact, ergonomic and easy to handheld Phased Array unit based on Total Focusing Method for easy-going imaging of inspection objects with two-dimensional and three-dimensional visualization and evaluation of inspection results.
>

32:128PR PAUT & 2-ch TOFD Flaw Detector: SyncScan 2

●32:128PR PAUT with optional 2-ch TOFD to maximize your efficiency ●Support PR mode for corrosi
...
on inspection ●Multiple solutions for welds & corrosion ●Faster scan speed (Approximately 3 meters/minute) ●Light weight: 4kg only including battery
>

TESTD-PT SYSTEM

Pulse thermography is a non-contact test method that is ideal for the characterization of thin fil
...
ms and coatings or the detection of defects. With a remarquable short test time and a high detection sensitivity, the Telops TESTD-PT is the perfect tool for non- destructive testing. With such high frame rates, it is even possible to investigate highly conductive or diffusive materials.
>

Extended Range Variable Wall® Piping Calibration Blocks for Longseam Inspection

This set of two blocks has been specially designed for situations where ultrasonic examination tak
...
es place circumferentially or “around the curve” for applications such as inspection of longseam welds in piping and vessels. Jointly designed by PH Tool and Holloway NDT, the blocks feature side-drilled hole reflectors positioned within novel compound-curves, each with multiple thickness steps. The unique design results in a light and compact form factor, with the largest block weighing just over 15 lbs and spanning just 16 ¾”. Coverage is provided for nominal pipe sizes from 6” to 10” in the small block and 12” to a whopping 56” in the large block. The compound OD curves and multiple wall thicknesses actually exceed ASME requirements, providing exceptional signal response and measurement accuracy. Properly managing beam divergence off the ID and stabilizing beam skew due to probe rocking is essential to maintaining a consistent calibration when inspecting lengthwise on curved surfaces.
>

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window