where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -
EWGAE 2012 |Website| by NDT.net

30th European Conference on Acoustic Emission Testing & 7th International Conference on Acoustic Emission at University of Granada, 12-15 September 2012

Share ...     

Keywords Authors & Institutions
Table of Contents
105 Articles in
Issue: 2012-11
Filter Results ...
Exhibitors (3)
EXTENDE.. 1
Vallen-Systeme.. 2
Title / Author(s) / Keywords Session
AE for Materials Characterization
Effect of Plastic Strain on Low-Cycle Fatigue Life and Fatigue Damage Detection
Y. Mizutani30, M. Ohta, A. Todoroki18
Department of Mechanical Sciences and Engineering; Tokyo Institute of Technology45, Tokyo, Japan
Structural integrity, fatigue damage, crack detection, Acoustic Emission (AE), damage detection, austenitic stainless steel, Low-cycle fatigue

AE for Materials Characterization
AE for Materials Characterization
Assessment of Sound Emission Phenomena at a Boundary Layer During Steel Quenching
F. Ravnik5, J. Grum78
Faculty of mechanical engineering; University of Ljubljana99, Ljubljana, Slovenia
Acoustic Emission (AE), Quenching, sound emission, sound pressure level, Acoustic spectrograph, vapor film

AE for Materials Characterization
AE for Materials Characterization
Mechanisms of Plastic Deformation and Acoustic Emission in ZK60 Mg Alloy
A. Vinogradov13, A. Danyuk3, E. Pomponi4
Laboratory for the Physics of Strength of Materials and Intelligent Diagnostic Systems; Togliatti State University11, Togliatti , Russia

AE for Materials Characterization
AE for Materials Characterization
AE Studies on the Durability of Flexible Dye-Sensitized Solar Cells
S. Wakayama110, N. Takagi1, T. Sakai12, M. Ikegami2, T. Miyasaka2
1Department of Mechanical Engineering; Tokyo Metropolitan University14, Tokyo, Japan
2Graduate School of Engineering; Toin University of Yokohama10, Yokohama, Japan
crack detection, thin film, Acoustic Emission (AE), Microdamage Accumulation, Transparent Conductive Oxide Film, Dye-Sensitized Solar Cells

AE for Materials Characterization
AE for Materials Characterization
Evaluation of AE Sources during Tensile Deformation of Al-Mg-Si Alloys with Different Heat Treatment
K. Yoshida117, Y. Tokuyama22, Y. Yasuhara2, H. Nishino213
1Faculty of Science and Engineering; Tokushima Bunri University3, Kagawa, Japan
2Department of Mechanical Engineering; University of Tokushima 22, Tokushima, Japan
materials characterization, Lamb Waves, Acoustic Emission (AE), tensile tests, alloys

AE for Materials Characterization
AE in Advanced Composites
Evaluation of the Destruction Process of Metal-Composite Cylinders with Use of Acoustic Emission Method
J. Schmidt8, M. Nowak15, I. Baran22
Laboratory of Applied Research; Cracow University of Technology29, Krakow, Poland
composite, Acoustic Emission (AE), hybrid cylinders

AE in Advanced Composites
AE in Advanced Composites
An Investigation of the Static Damage Mechanisms of Pultruded Glass Fiber Reinforced Polymers with Artificial Neural Networks
D. Crivelli18, M. Guagliano15, A. Monici27
1Department of Mechanics; Politecnico di Milano84, Milano, Italy
2ETS Sistemi Industriali Srl7, Agrate Brianza, MI, Italy
fibre reinforced materials, composite, neural network, Acoustic Emission (AE), self organizing map, glass fiber, pultruded composites

AE in Advanced Composites
AE in Advanced Composites
Failure Analysis of NOL-Ring Specimens by Acoustic Emission
M. Plöckl1, M. Sause142, J. Scharringhausen2, S. Horn17
1Institute for Physics, Experimentalphysik II; University of Augsburg43, Augsburg, Germany
2MT Aerospace AG 4, Augsburg, Germany
AE source location, fibre reinforced materials, pattern recognition, Acoustic Emission (AE),

AE in Advanced Composites
AE in Advanced Composites and Lamb waves
Influence of Internal Discontinuities on Ultrasonic Signal Propagation in Carbon Fiber Reinforced Plastics
M. Sause42, S. Horn7
Institute for Physics, Experimentalphysik II; University of Augsburg43, Augsburg, Germany
CFRP, finite element method (FEM), wave propagation, Lamb Waves, Acoustic Emission (AE),

AE in Advanced Composites and Lamb waves
AE in Advanced Composites and Lamb waves
A Waveform-Based Study of AE Wave Propagation by Use of Eight Sensors on a Composite Pressure Vessel
M. Hamstad22
Department of Mechanical and Materials Engineering; University of Denver24, Denver, CO, USA
AE source location, pressure vessel, composite, CFRP, wave propagation, Lamb Waves, localisation of damage, Acoustic Emission (AE), group velocities, composite pressure vessels, Pencil lead breaks, source location

AE in Advanced Composites and Lamb waves
AE in Advanced Composites and Lamb waves
An Improved Acousto-Ultrasonic Scheme with Lamb Wave Mode Separation and Damping Factor in CFRP Plates
A. Gallego130, K. Ono235
1Department of Applied Physics; University of Granada34, Granada, Spain
2Department of Materials Science and Engineering; University of California34, Los Angeles, CA, USA
AU (acousto-ultrasonics), composite, Lamb Waves, attenuation, Acoustic Emission (AE),

AE in Advanced Composites and Lamb waves
AE in Aerospace Structures and Composites
Remote AE Monitoring of Fatigue Crack Growth in Complex Aircraft Structures
M. Chlada32, Z. Převorovský65
aNDT department bInstitute of Thermomechanics; Czech Academy of Sciences (CAS)111, Prague, Czech Republic
NDT-wide, Acoustic Emission (AE), neural network, fatigue damage, structural health monitoring (SHM), crack propagation

AE in Aerospace Structures and Composites
AE in Aerospace Structures and Composites
Benefits of Acoustic Emission for the Testing of Aerospace Composite Assemblies
L. Adam13, E. Bonhomme2, C. Chirol2, A. Proust111
1Mistras Group, SAS19, Sucy-en-Brie, France
2Operations SAS; AIRBUS OPERATIONS SAS22, Toulouse, France
Acoustic Emission (AE), aerospace, composite, structures assembling, mechanical tests

AE in Aerospace Structures and Composites
AE in Aerospace Structures and Composites
Non Destructive Testing of GAIA Frame by Means of Acoustic Emission Monitoring During Launch Simulation Tests
F. Levallois1, A. Sobeczko1, D. Marlot24, J. Lenain28, A. Proust211
1ASTRIUM SAS, TOULOUSE Cedex, France
2Mistras Group, SAS19, Sucy-en-Brie, France
crack detection, composite, aerospace, instrumentation, Acoustic Emission (AE)

AE in Aerospace Structures and Composites
AE in Concrete and Construction Materials
Low-Level AE During Long-Term Monitoring of Concrete
A. Pollock4
MISTRAS Products & Systems72, Princeton Junction, NJ, USA
reinforced concrete, concrete, civil engineering, Acoustic Emission (AE),

AE in Concrete and Construction Materials
AE in Concrete and Construction Materials
Multivariate and Artificial Neural Network Analyses of AE Data during Long Time Corrosion Monitoring of a Post-Tensioned Concrete Beam
E. Proverbio11, L. Calabrese7, G. Campanella7
Dept. Industrial Chemistry and Material Engineering; University of Messina23, Messina, Italy
Acoustic Emission (AE), neural network, stress corrosion cracking (SCC), Kohonen map, pre-stressed concrete

AE in Concrete and Construction Materials
AE in Concrete and Construction Materials
Initial Results on Acoustic Amission Detection in Masonry with Optical Fibre Sensors
E. Verstrynge5, M. Wevers54
aDepartment of Civil Engineering bDepartment of Metallurgy and Materials Engineering; Catholic University of Leuven (KU Leuven) 101, Leuven, Belgium
masonry, Acoustic Emission (AE), Optical Fiber Sensors

AE in Concrete and Construction Materials
AE in Different Applications
AE and Other Observations during Cyclic Testing of A572 Steel Laboratory Specimens
A. Pollock14, J. Yu2, P. Ziehl23
1MISTRAS Products & Systems72, Princeton Junction, NJ, USA
2Department of Civil and Environmental Engineering; University of South Carolina 13, Columbia, SC, USA
structural health monitoring (SHM), crack propagation, civil engineering, Acoustic Emission (AE), NDT-wide, cruciform, compact tension specimen, plastic zone, bridges, A572 steel

AE in Different Applications
AE in Different Applications
Correlation Between Acoustic Emission and Torque in Drilling
M. Gomez1,22, J. Ruzzante1,214
1Elastic Waves Group, Constituyentes Atomic Center; National Comission of Atomic Energy(CNEA)34, Buenos Aires, Argentina
2Center of Nondestructive and Structural Testing, Delta Regional Faculty; National Technological University 7, Buenos Aires, Argentina
Acoustic Emission (AE), acoustic emission, drilling, wear, torque, AE features, mean power

AE in Different Applications
AE in Different Applications
Health Monitoring of a NEG-MICON 750kW Wind Turbine Blades with Acoustic Emission
D. Papasalouros110, N. Tsopelas14, I. Ladis13, D. Kouroussis16, A. Anastasopoulos120, D. Lekou24, F. Mouzakis12
1Mistras Group Hellas ABEE36, Athens, Greece
2Wind Energy Department; Centre for Renewable Energy Sources and Saving (CRES)6, Attiki, Greece
Acoustic Emission (AE), Structural Health Monitoring, Composite Materials, Wind Turbine Blades, Automated AE data processing

AE in Different Applications
 
Page:
 -1-   2   3   4   5   6 
next pageNext
Actual Cooperations
Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window