where expertise comes together - since 1996 -

The Largest Open Access Portal of Nondestructive Testing (NDT)

Conference Proceedings, Articles, News, Exhibition, Forum, Network and more

where expertise comes together
- since 1996 -
Beta-Version of this Page View
NDT.net Issue - 2017-10 - NEWS
NDT.net Issue: 2017-10
Publication: e-Journal of Nondestructive Testing (NDT) ISSN 1435-4934 (NDT.net Journal)
NEWS

Sonotron NDT announces the new release of the RODScan PA modality ultrasonic inspection SW application

Sonotron NDT68, Rehovot, Israel

The turbine shafts are the extremely loaded parts of the rotors. The high mechanical stresses accompanied with elevated ambient temperature may cause appearance and growing of fatigue cracks followed by catastrophic failure. Thus the axis vicinity areas of rotor shafts have been inspected ultrasonically on regular basis during the scheduled shutdowns. Usually the 100% inspection of the hollow shafts is performed with the use of probe system scanning over the entire rotor length from the bored surface (ID side). For the solid shafts the inspection is performed from the OD surface; the same inspection is suitable for the screening of the hollow shafts in the cross sections in between the rings carrying the turbine blades.

[+]

Depending on the rotor type the inspection with use of conventional probes lasts 6...7 work shifts. To reduce the inspection time to 1 work shift there was an inspection procedure based on use of the PA modality developed by Sonotron NDT in cooperation with IEC several years ago. The inspection is implemented with the use of ISONIC series PA instruments (ISONIC 3510, ISONIC 2010, ISONIC 2009 UPA-Scope) through running of the RODScan Inspection SW application utilizing the True-to-Geometry (True-to-Shape) S-Scan coverage and imaging strategy. The complete cross sectional view is formed in one revolution of the shaft through superimposing of all S-Scan images obtained within entire revolution. The raw data A-Scans (primary and superimposed according to the settled focal laws) composing every recorded S-Scan image are stored completely and may be played back off-line providing all-standardscompliant A-Scan based evaluation. The RODScan inspection SW option is used widely across the world.

In the recently issued new SW release for the ISONIC series portable PA instruments the RODScan inspection mode allows performing of the S-Scan coverage and capturing of the S-Scans over entire shaft rotation following both EquPAS and FMC/TFM protocols simultaneously significantly increasing the precision of the defects evaluation. This is especially important for the monitoring of the discontinuities in the shaft material until developed to the critical shape / dimensions. The increased inspection speed and precision of the evaluation allow prolonging of the service life and save the expenses for the turbines health monitoring.

The related links:

 
Visit: Sonotron NDT

Feedback: ()

Share:
More from "Sonotron NDT" (5 of 67)
2019-07-01On-Line Supervising and Support of UT Technician
2019-06-01Air-to-Soil Interface: Rapid Screening and Mapping of Corrosion Damages in the Steel Pole Legs beneath the Soil Level
2019-04-01PAUT: Inspection of complex geometry fracture critical parts – manual probe manipulation
2019-03-01PAUT: Corrosion detection/survey under shell/tank bottom repairs using lap-welded patch plates
2019-02-01PAUT: In-Service Corrosion Survey of Critical Zone in the Annular Rings in the Above Ground Storage Tanks
... All 67 Details >

More Videos in NDT.net

Share...
We use technical and analytics cookies to ensure that we will give you the best experience of our website - More Info
Accept
top
this is debug window